Westinghouse UW32SC1W manual Antenna Installation Safety, Outdoor Antenna Grounding

Page 12

English

IMPORTANT INFORMATION

ANTENNA INSTALLATION SAFETY

Outdoor Antenna Grounding

If an outside antenna or cable system is connected to the LED TV, be sure the antenna or cable system is grounded to prevent voltage surges and built-up static charges. Article 810 of the National Electrical Code, ANS/NFPA 70, provides information on proper grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, connection to grounding electrodes, and requirements for the grounding electrode.

Antenna Grounding According to the National

Electrical Code, ANSI/NFPA 70

Grounding clamps

Electric service equipment

NEC: National Electrical Code

Antenna lead in wire

Antenna discharge unit (NEC Section 810-20)

Grounding Conductors

(NEC Section 810-21)

Grounding clamps

Power service grounding electrode system (NEC Art 250 part H)

Lightning

For added protection for the LED TV during a lightning storm, or when it is left unattended and unused for long periods of time, unplug it from the wall outlet and disconnect the antenna or cable system. DO NOT disconnect the antenna or the power cord during a heavy storm—lightning may strike while you are holding the cable cord, causing serious injury. Turn off the LED TV and wait for the weather to improve.

Power lines

An outside antenna system should not be located in the vicinity of overhead power lines or other electric light or power circuits, or where it can fall into such power lines or circuits. When installing an outside antenna system, extreme care should be taken to keep from touching such power lines or circuits as contact with them might be fatal.

8

Image 12

Contents UW32SC1W Page Table of Contents Connecting AC Power Initial Setup Digital Television Transition Notice Energy Star DisclaimerImportant Information SJT FCC Compliance Statement FCC WarningImportant Safety Instructions Circuit Overload LED TV Antenna Installation Safety Outdoor Antenna GroundingTo clean the screen To clean the casePackage Contents Control Panel DescriptionTerminals FunctionRemote Control DescriptionRemote Control Operation Installing the Remote Control BatteriesRemote Control Transmission Range Installing the LED TV Base LED TV BaseRemoving the LED TV Base Antenna Connection Outdoor Antenna ConnectionCable TV CTV/DTV Connection External Device Connections External Device ConnectionsFollowing diagram shows the external device connections Power Connection Connecting AC PowerInitial Setup Cable or Satellite BOX Connection Setup Power On ModeSelect Language Time ZoneCable/Satellite Box Input RF WarningOther Input Source Connection Setup Lets Get ConnectedSelect Input Source Antenna or Coacial Cable Input Connection Setup Let’s Get ConnectedSelect Channel Scan Type Channel Scan in progressTurning the Power on and OFF Adjusting the VolumeBasic Operations Using the Ch / Buttons Using the Channel KeysUsing the Favorite Keys Using the Individual Input KeysUsing the Input Key Adjusting the Display FormatSelect source using Input Key Press Input Format OptionsSetup Menus Setup Menu OperationDisplaying the setup menu screen Navigating the setup menu screenPicture Settings PicturePicture mode Adjusting BrightnessAdjusting Contrast BrightnessColor TintSharpness VGA Settings Adjusting Screen SizeScreen Size VGA sourceAuto Adjust PositionClock Phase ResetColor Temperature Adjusting VGA SettingsAdvanced Picture Settings Film Mode Off/OnDynamic Contrast Off/On Noise Reduction Off/OnSound Settings SoundSound mode Adjusting BassAdjusting Treble BassAdjusting Balance BalanceDigital Audio Output PCM/Raw/Off Equalizer Settings SRS Trusurround SettingsChannel List ChannelChannel Setting Favorite ListChange the settings Signal TypeAuto Channel Search Skip & FavoriteLock Parental Control Parental ControlUS V-Chip Rating Description TV-MACanada V-Chip Rating system used at CanadaBlock UnRated Show Downloadable RatingClear Downloadable Data Change Password Changing PasswordSource Lock Setup Closed CaptionsCaption Display Analog Caption TypeDigital CC Preset Default/Custom Adjusting Menu Language Menu LanguageAuto Clock OSD Timer Power LightNo Signal Power Off No Operation Power OffAll Reset Blue BackWall Mount Installation Reminders Wall Mount OptionTroubleshooting Problem Corrective ActionEnglish Make sure the audio input cable is properly Specifications SpecificationWith stand