Technika STBHDV2010 user manual Inserting Batteries in the Remote Control

Page 7

Inserting Batteries in the Remote Control

•Remove the battery cover located on the back of the remote control by gently pulling backwards from the indicated part.

•Insert two AAA/R3 (2 X 1.5Volt) or equivalent type batteries inside. Place the batteries in the right directions observing the polarity symbols (+/-) and replace the battery cover.

•While using the remote control, you should direct it towards the front panel of the receiver. Remote range is approximately 7m/23ft.

•If your receiver no longer responds to the remote control. it is probable that the batteries are exhausted. If so you can still use the local buttons of the receiver. You can replace batteries after they are exhausted. Please use only the leak proof batteries.

Note : Remove the batteries from the remote control when it is not to be used for a long period. Otherwise it can be damaged due to any leakage of batteries.

Connecting the Set-Top Box to a TV Set

You can connect your set top box to a TV by using the following methods:

1.HDMI connection: If your TV has an HDMI input, you can simply connect the set top box to your TV by using an HDMI cable between the HDMI OUT connector on your Set-Top Box and the HDMI INPUT connector on your TV. HDMI connection provides a better picture/sound quality.

2.SCART connection: You can also connect the set top box to your TV by using the scart socket. Use a scart cable to connect the set-top-box to your TV.

English - 6 -

Page 6 Page 8
Image 7
Page 6 Page 8
Contents STBHDV2010 Contents Introduction FeaturesAccessories Safety Precautions Safe use and care of your equipment Important Safety informationOverview of the Remote Control Front Panel Rear Panel Viewing Controls and Connections of the Set-Top-BoxConnecting the Set-Top Box to a TV Set Inserting Batteries in the Remote ControlPower On-Off Power ConnectionAntenna Connection Mute First Time InstallationAdjusting the Volume Changing ChannelsMenu System On-Screen InformationManaging Stations Channel List Deleting Channels Setting FavouritesOperating the Channel List Moving a ChannelConguration Conguring Settings Setup MenuViewing Electronic Programme Guide EPG Event OptionsActive channels Output SettingsScan Encrypted Audio Description Receiver UpgradeParental Settings Low PowerInstallation IP SettingsConguring Language Preferences No Channels Have Been Added Yet No SignalOSD Warning Messages Displaying TextBattery TroubleshootingProblem Possible Reasons What To Do Digital Capabilities General CharacteristicsRemote Control Hardware CongurationTv Scart AudioDigital Audio Data In / OutFollowing information is only for EU-member states
Top Page Image Contents