TV Type, TV Out, Favourite Mode, Channel List

TV Type

Digital terrestrial television channels can broadcast programmes in a widescreen format which must be output differently to normal and widescreen TV sets. This function tells the receiver the screen format of the TV connected so that broadcasts are displayed correctly. Highlight the TV Type line in the Conﬁguration menu and use the “”/“” keys to select 4:3 if you have a standard TV set connected or 16:9 if it is a widescreen TV. If you choose “Auto”, the TV type will be set automatically according to the broadcasted programme. This function duplicates the selection made at the time of ﬁrst installation and can be used if you change TV sets.

TV Out

The receiver can output RGB and CVBS signal from the TV SCART on the rear panel. Although the RGB format results in a better quality picture, not all equipment can cope with an RGB signal.

Favourite Mode

This function enables or disables the favourite channel list mode by pressing “”/“” buttons. If a favourites list exists it will switch to the list number selected. If there is no favourite listing, a warning message is displayed.

Channel List

Use “”/“” buttons to go to Channel List option. Use “”/“” buttons to toggle Channel List Mode. If you select “TV Only” you navigate through only TV channels, if you select “Radio Only” you navigate through only radio channels, if you navigate “Text Only” you navigate through only Text channels with the PR+/PR- buttons. If you choose “Show All” all, channels can be navigated with the PR+/PR- buttons. To save the recent changes and exit; press the MENU button.

Scan Encrypted

Use“”/“” buttons to go to the Scan Encrypted Channels option. Use “”/“” buttons to toggle YES or NO the searching for encrypted channels.

Auto Power Down

This box will automatically switched from active mode into standby mode, after less than three hours in active mode, following the last user interaction and/or a channel change with an alert message two minutes before going in to standby mode. The Automatic power-down will be set as default and the user will be able to change Automatic power down to on or off in the menu.

Receiver Upgrade

Over Air Download (OAD): To ensure that your STB always has the most up todate information. Please ensure that after use it is set to its standby mode. The STB automatically powers up at 3.00 A.M. each day and searches for any new information which may be broadcast and will download this to your receiver automatically. This operation will normally take approximately 30 minutes. If you have an important recording to make at 3.00 A.M. which must not have a 30 minutes interrupt then you can disable the auto OAD search by performing the following:

•Press Menu button and using the “”/“” buttons to choose Setup and press the OK button.

•Highlight Conﬁguration menu with “”/“” keys and pres OK.

•Use “”/“” buttons to choose “RECEIVER UPGRADE” and press OK button.

•Using the left / right button change “Automatic scanning” from Enabled to Disabled.

•Highlight “Scan for upgrade” menu with “”/“” keys and press OK to commence upgrade.

Do not forget to re enable the automatic OAD function after you have made your recording by repeating the above instructions but this time selecting ENABLE.

Parental Locking

Use “”/“” buttons to go to Parental Lock option. Press OK button to enter the menu. A box asking for the lock key is displayed. The key is set to “0000” initially. Enter lock key. If it is incorrect, “Wrong Pin” is displayed. If it is correct, the Parental Control Menu is displayed.

English - 16 -