Technika T835 user manual Power Connection, Power On-Off, Antenna Connection, Auto Power Down

Page 7

Power Connection

IMPORTANT: The set-top box is designed to operate on 12 V DC. For this, an adaptor is used which gives 12 V voltage. Connect this adaptor to a system that supplies 220-240V AC,50Hz.

After unpacking, allow the set-top box to reach the ambient room temperature before you connect the set to the mains.

UK

Power On-Off

Connect all cables before plugging into the mains. After plugging in the mains cord of the set-top-box to the mains supply, a light will be seen on the front panel (Standby mode). When the set-top-box is first powered up please wait until the box is initialized before activating the receiver since booting of software will take some time. Make sure that all cable connections are in place. Plug the mains. Please wait until unit is initialized. This may take almost a minute.

This product conforms the latest European Union Power Consumption Regulations and features low power standby mode. Product enters into the low power standby mode approximately 2-3 minutes later after you press standby button to turn off the unit. Until low power mode is activated, clock will be displayed at the display. When the low power mode is activated, display will be shut down. When you press standby button during low power mode, it may take a minute until product is initialised. However if you press standby button before low power mode is activated unit will be initialized in a couple of seconds (Active standby mode). Although it is not recommended for enviromental reasons, you may disable low power mode in your product at setup –configuration menu.

Auto Power Down:

This box will automatically switched from active mode into standby mode, after less than three hours in active mode, following the last user interaction and/or a channel change with an alert message two minutes before going in to standby mode. The Automatic power-down will be set as default and the user will be able to change Automatic power down to on or off in the menu

Important Note : If there is any ongoing programme recording or if any EPG programme recordings and/or manual recordings is set to a nearby time, the unit does not switch to low power mode and remains in active standby mode until recording tasks have been finished. At low power mode, the unit initializes a couple of minutes before the actual time of the incoming recording task.

Important Note : The unit initializes time to time to receive updates from EPG broadcast in order to sycnronize EPG recording tasks properly. After getting updates, the unit switches to low power mode automatically. This takes a short while and it is not a malfunction.

Antenna Connection

35026858

ANTENNA

ANTENNA

OPTICAL

SCART (TV)

IN

OUT

AUDIO OUT

DC IN

English - 6 -

Image 7
Contents 500Gb T835 Contents Safety Precautions AccessoriesPower Cord Overview of the Remote Control Connections Power Supply DCAntenna in Aerial input Connection to the Tv Remote ControlAntenna Connection Power ConnectionPower On-Off Auto Power DownMenu System Main InterfaceProgramme Guide Select Channel Record/Delete TimerCheck Conflicts Programme OptionSet Reminder/Delete Reminder Multiple/Alternative Timer RecordSplit Record Timers Play Options Recordings LibraryEdit Recordings Chapter Options SetupMain Title Recording TitleHard Disk Info Max Time ShiftAuto Discard Format DiskUnrecordable Material If a power failure occursConfiguration Recording FormatTV Type Favourite ModeAuto Power Down Receiver UpgradeInstallation Volume Control Specific Functions of Remote ControlTime ShiftingPause Live Recording English Problem Possible Problem What to do General troubleshootingDigital Capabilities General CharacteristicsHardware Configuration Remote ControlDigital Audio TunersHard Disk Front PanelFollowing information is only for EU-member states