Operation of Universal Remote Control (Continued)
POWER |
|
| |
TV | DVD | DISPLAY | INPUT |
TV | VCR | ||
|
|
| |
POWER |
|
|
|
1 2 3
REMOTE | 4 | 5 | 6 |
KEYPAD | 7 | 8 | 9 |
| |||
| FLASHBACK |
| ENTER |
|
| 0 | 100 |
| PERSONAL PREFERENCE | ||
A | B | C | D |
| VOL | CH | VOL |
|
|
—+
CH
MENUMUTE
CATV TV
DVD VCR
REW PLAY FF
PAUSE STOP REC CH/SKIP
DVD/VCR POWER
INPUT
DISPLAY
CHANNEL UP (a)/ DOWN (s)
CATV/DVD-
TV/VCR
•How to identify a DVD
The remote control may already be set to operate your DVD. Try this initial check before going on to the following “identifying” section.
(1)Slide
(2)Point Remote towards DVD and press DVD/
VCR POWER.
(3)Does the Remote turn the DVD ON and OFF?
•If yes, the Remote is ready to operate the DVD and no further steps are needed.
•If no, continue to the “identifying” section.
Direct Entry Method.
Refer to the following steps and list to quickly find the remote control code for your accessory DVD.
•First look up your DVD’s remote control code number before going through the Direct Entry Method.
(1)Slide
(2)Press and hold down INPUT and CH s on your remote control.
Then release both buttons.
(3)Within 10 seconds after releasing INPUT and CH s, enter your DVDs
•The remote control is now ready to send commands to your DVD.
DVD BRAND | REMOTE CONTROL | |
CODE NUMBER | ||
| ||
Denon | 02 | |
JVC | 09 | |
Magnavox | 04 | |
Marantz | 04 | |
Mitsubishi | 06 | |
Panasonic | 02 | |
Philips | 04 | |
Pioneer | 08 | |
Proscan | 03 | |
RCA | 03 | |
Samsung | 07 | |
Sharp | 01, 10 | |
Sony | 05 | |
Toshiba | 04 | |
Yamaha | 02 | |
Zenith | 04 | |
|
|
Note:
Depending on the model, year produced, brand, and type of DVD, some models may not be compatible with the remote control.
44
44 | 12/21/02, 3:42 PM |
Dimension: 140 X 215 mm