Sharp LC 30HV2U operation manual Viewing an image from a computer, Connecting a computer, Computer

Using external equipment

Viewing an image from a computer

Connecting a computer

Use the PC terminals to connect a computer.

A

•The PC input terminals are DDC1/2B-compatible.

•Refer to page 71 for a list of computer signals compatible with the System.

AVC System (front view)

RGB cable (commercially available)

ø3.5 mm stereo minijack cable (commercially available)

Computer

Signal names for 15-pin mini D-sub connecter

5	4	3	2	1	Pin No.	Signal name	Pin No.	Signal name	Pin No.	Signal name
					1	R	6	GND (Ground)	q	Not connected
10	9	8	7
					6	G		GND (Ground)		SDA
15	14	13	12	11	2		7		w
					3	B	8	GND (Ground)	e	HD
					4	Not connected	9	+5V	r	VD
					5	CSYNC	0	GND (Ground)	t	SCL

A

•Macintosh adaptor may be required for use for some Macintosh computers.

	TV CBL	VCR DVD
TV	/SAT	/LD
	/DTV
POWER	ANT-A/B	INPUT
AV	FRONT
MODE	SURROUND	MTS	CC
	TWIN
	PICTURE	SELECT
VIEW		SUB	TWIN CH
MODE	FREEZE	INPUT
DISPLAY	SLEEP	EDIT/	LEARN

1	2	3
4	5	6
7	8	9
	0	100 ENT

INPUT SOURCE

TV

INPUT1

INPUT2

INPUT3

INPUT4

PC

Displaying an image from a computer

When connecting to a computer, the correct input signal type is automatically detected. If the computer image does not come in clearly, you may need to set the Auto Sync. adjustment on the “Auto Sync.” in the menu. (See page 46.)

You only need to select the input source on the “INPUT SOURCE” menu.

To view an image from a computer, select “PC” from the “INPUT SOURCE” menu using INPUT on the remote control unit or on the Dispaly. (See page 47.)

A

•Each time INPUT is pressed, the input source toggles.

•PC INPUT terminals cannot be used for audiovisual equipment. Use the INPUT 3 (HD) terminal on the rear of the AVC System when connecting audiovisual equipment with an RGB signal. (See page 41.)

43