Sharp LC70LE735U Preparation, Antennas, Installing Batteries in the Remote Control Unit

Page 12

Preparation

Antennas

To enjoy a clearer picture, use an outdoor antenna. The following is a brief explanation of the types of connections that are used for a coaxial cable. If your outdoor antenna uses a 75-ohm coaxial cable with an F-type connector, plug it into the antenna terminal at the rear of the TV set. For connecting the antenna cable to the TV, use commercially available cables.

Connecting Antenna Cable

Connect the antenna cable to the TV using one of the methods in the illustration as shown (1, 2, 3 or 4).

 

 

Home Antenna

1 Cable without a CATV

Cable TV lead-In

terminal (75-ohm)

 

converter

 

Coaxial cable

 

 

2 VHF/UHF antenna

75-ohm coaxial cable (round)

Home Antenna terminal (75-ohm)

3 Combination VHF/

UHF antenna

4 Separate VHF/UHF

antenna

 

 

 

 

Coaxial cable

 

75-ohm coaxial cable (round)

 

 

 

 

or

 

 

 

300-ohm twin-lead cable (flat)

300/75-ohm adapter

 

 

 

VHF

UHF

300-ohm

 

 

ANTENNA

ANTENNA

 

 

twin-lead cable

 

 

 

 

 

 

 

 

 

IN

OUT

 

300-ohm twin-lead cable

Combiner

 

 

 

 

or 75-ohm coaxial cable

 

 

To TV antenna terminal

1.A 75-ohm system is generally a round cable with F-type connector that can easily be attached to a terminal without tools.

2.A 300-ohm system is a fl at “twin-lead” cable that can be attached to a 75-ohm terminal through a 300/75-ohm adapter.

F-type connector

75-ohm coaxial cable (round)

300-ohm twin-lead cable (fl at)

NOTICE F-type connector should be finger-tightened only.

When connecting the RF cable to the TV set, do not tighten F-type connector with tools.

If tools are used, it may cause damage to your TV set. (The breaking of internal circuit, etc.)

F-type connector

75-ohm coaxial cable

Installing Batteries in the Remote Control Unit

If the remote control fails to operate TV functions, replace the batteries in the remote control unit.

1Open the battery cover.

2 Insert two “AAA” size batteries (supplied with 3 Close the battery cover. the product).

• Place the batteries with their terminals corresponding to the (e) and (f) indications in the battery compartment.

CAUTION

Improper use of batteries can result in chemical leakage or explosion. Be sure to follow the instructions below.

Do not mix batteries of different types. Different types of batteries have different characteristics.

Do not mix old and new batteries. Mixing old and new batteries can shorten the life of new batteries or cause chemical leakage in old batteries.

Remove batteries as soon as they are worn out. Chemicals that leak from batteries that come in contact with skin can cause a rash. If you fi nd any chemical leakage, wipe thoroughly with a cloth.

The batteries supplied with this product may have a shorter life expectancy due to storage conditions.

If you will not be using the remote control unit for an extended period of time, remove batteries from it.

10

Image 12
Contents LC-70LE735U Page LC-70LE735U Model No Serial NoFCC Compliance Statement Industry Canada StatementAdditional Safety Information Dear Sharp CustomerPrecautions when transporting the TV Caring for the cabinetChild Safety Caring for the front panel3D Glasses Contents Supplied Accessories Attaching the StandUsing the Remote Control Unit Insert the batteries into the remote control unit. SeeRemote control sensor Experiencing HD ImagesInstalling Batteries in the Remote Control Unit Connecting Antenna CablePreparation AntennasPart Names TV FrontTV Rear/Side Remote Control Unit Part NamesConnecting to video equipment or PC Connecting to audio equipmentIntroduction to Connections Types of ConnectionConnecting to External Equipment When using Hdmi cable Hdmi 1, 2, 3 orWhen using DVI-HDMI conversion cable Hdmi Connecting to External Equipment When using Component cable ComponentWhen using Composite cable Video 1 or Connecting a Surround System/Audio System When connecting an AV amplifier for surround systemWhen connecting an Audio amplifier HD Cable/Satellite set-top box HDMI-certified cable *1Connecting a PC When using analog RGB cable PCDVI-HDMI conversion cable Mm stereo minijack cable Turning On/Off the Power Initial InstallationLanguage Language setting Watching TVAir/Cable Antenna setting Watching TV Antenna & Cable/STBCH Search Channel search To watch TV via a set-top boxExamples of the settings confirmation screen Watching TV CompletedChanging Volume Sleep TimerDirect Button Operation Changing ChannelsPress Power Saving Example When the input source is TV, COMPONENT, Video 1 orDirect Button Operation Press InputClosed Captions and Digital Closed Captions Press CCExamples This will present the Closed Caption information displayPress View Mode You can select the screen sizeFor HD programs For 43 programsOn-Screen Display Menu On-Screen Display Menu OperationMenu Operation Buttons Lcfont embeddedMenu Items On-Screen Display MenuPicture Settings AV Mode Changing Pic.QualityOPC Setting Advanced Picture SettingsColor Temp Color Temperature Fine tuning the color temperatureGamma Adjustment Film Mode 32 pull-downAudio Settings Auto Volume3D Surround Bass EnhancerPower Control Power SavingNo Signal Off Audio OnlySystem Options View OptionInput Terminal Setting Menu DesignIcon Light Up Setting Demo ModeCaption Setup Game Play TimeInitial Setup EZ SetupBroadcasting Setup CH SetupReset Wall Mount Audio SetupIndividual Setup LanguageWhen setting an individual content-based rating item ChipChip is an electronic fi ltering device built into your TV Parental GuidelinesHow to temporarily release the V-CHIP Block Canadian English RatingsCanadian French Ratings Reactivating the temporarily released V-CHIP BlockSoftware Update InformationIdentification Digital Caption Info Digital Caption InformationUpdating the Software via the Network Call 1-800-BE-SHARPPress Enter to start checking the data in the USB Memory device Select Yes, and then press EnterDuring the data checking, Checking blinks After the screen shown below is displayed, pressEnjoying 3D Image Viewing Display Methods for 3D and 2D ImagesViewing 3D Images Enjoying 3D Image ViewingConfiguring the TV Settings to Enhance 3D Image Viewing Switching to the Previous ModeWatching 2D Images in 3D 3D Menu3D Setup 3D Glasses lenses 3D Glasses infrared receiverUsage range of the 3D Glasses Connecting a USB Memory Device/USB Hard Drive Connecting a Home Network Dlna ServerEnjoying Photo/Music/Video Playback Ethernet cable Home network Dlna serverWhen displaying the data with the Apps Select the Files to Play BackEnjoying Photo/Music/Video Playback USB memory devicePhoto Mode Playing Back Files on a USB Memory DeviceSelect Slide Show Interval Select Slide Show BGMButtons for slide show BGM select operation Remove USB DeviceMusic Mode Video ModeButtons for playing mode Buttons for music mode Set/Reset All Auto PlayUsing the operation panel Menu for playing modeUSB Menu Menu for file selecting operations Title Edition/ChapterDivX Setup Press a/b to select DivX Setup, and then press EnterUSB Device Compatibility DivX VOD registration DivX VOD deregistrationPlaying Back Files on a Home Network Dlna Server Home Network Dlna MenuButtons Description C/d Yellow Display the Home Network Dlna Menu ScreenButtons for playing mode Home Network Dlna Server CompatibilityPresetting Remote Control Function Presetting manufacturer codesOther Viewing Options Operating the Connected EquipmentOther Viewing Options Manufacturer codes Using Aquos Link Controlling Hdmi Equipment Using Aquos LinkUsing Aquos Link Aquos Link SetupOne Touch Playback Link Operation Menu One Touch RecordingStart/Stop Recording Displaying the Link Operation MenuUsing the Device Operation Panel Timer RecordingPlayback of Titles Using Aquos Link Manually Changing Aquos Audio Speaker System’s Sound ModeUsing a PC Displaying a PC Image on the ScreenStretch Dot by Dot Adjusting the PC Image Setting Audio InputPC Compatibility Chart Using a PCControl of the TV Using a PC Command table Commands not indicated here are not guaranteed to operateUsing the Internet Connecting to the Internet+Using an Ethernet cable About the original homeUsing the Internet +Using the wireless LANInternet Setup Interactive ServiceWireless Setup Checking Your Internet ConnectionDisplaying Updated Information and Support Service Original HomeAquos Advantage Live Entering Text Software Keyboard Using the Browser Featured ContentWhen z is displayed in a About linksUsing the Toolbar Using Tabs Selected itemSelected item Description Select This Close This TabSaving the URL of the Current Opening a BookmarkedEditing Bookmarks Browser Settings Security SettingsView Settings Using Applications via the Internet Deactivating Netflix FunctionDeactivating the Vudu Function Disclaimers Appendix Removing the StandBefore detaching or attaching the stand, unplug the AC cord Before attaching/detaching the standSetting the TV on the Wall Optional AccessoriesUsing an optional bracket to mount the TV AppendixTroubleshooting Pages 24Pages 27 Troubleshooting 3D Images Troubleshooting Error MessageTrademarks Secret number isSpecifications Model LC-70LE735UWireless LAN SpecificationsSpecification Information on the Software License for This Product Software compositionSoftware developed by Sharp and open source software Obtaining source codeInformation on the Software License for This Product Software CopyrightsCalling for Service Limited WarrantyPage Dimensional Drawings Unit inch mm Unité pouce mm Unidad pulgada mmSharp Electronics Corporation Hdtv Programming Types of ConnectionProgrammation Hdtv Types de connexionsConnecting a Cable/Satellite Set-top Box Connecting Multiple Devices to the TVConnecting a Cable/Satellite Set-top Box and VCR AUDIO-L White