Appendix
Removing the Stand
• Before detaching (or attaching) the stand, unplug the AC cord from the AC INPUT terminal.
CAUTION
• Do not remove the stand from the TV unless using an optional wall mount bracket to mount it.
Before attaching/detaching the stand
•Before performing work, make sure to turn off the TV.
•Before performing work spread cushioning over the base area to lay the TV on. This will prevent it from being damaged.
1
Hex key
Unfasten the four screws used to secure the stand in place.
2
Detach the stand from the TV. (Hold the stand so it will not drop from the edge of the base area.)
• To attach the stand, perform the above steps in reverse order.
Setting the TV on the Wall
CAUTION
•This TV should be mounted on the wall only with the wall mount bracket
•Installing the TV requires special skill that should only be performed by qualified service personnel. Customers should not attempt to do the work themselves. SHARP bears no responsibility for improper mounting or mounting that results in accident or injury.
Using an optional bracket to mount the TV
•You can ask a qualifi ed service professional about using an optional
•Carefully read the instructions that come with the bracket before beginning work.
Hanging on the wall
(See the bracket instructions for details.)
CAUTION
About setting the TV angle
•The “c” position is at the center of the display.
• The “b” position is at the center of the display.
• The “f” position is at the center of the display.
• Refer to the operation manual of AN- 52AG4 for details.
• Install the TV vertically on the wall. If the TV is installed at an angle, the Disc Drive may not operate normally.
•Detach the cable clamp on the rear of the TV when using the optional mount bracket.
•To use this TV mounted on a wall, remove the covers at the 4 locations on the rear of the TV, and then use the screws supplied with the wall mount bracket to secure the bracket to the rear of the TV.
54