Sharp LC-52BD80U, LC-42BD80U, LC-46BD80U operation manual Precautions when transporting the TV

Page 6

IMPORTANT SAFETY INSTRUCTIONS

Outdoor Antenna Grounding — If an outside antenna is connected to the television equipment, be sure the antenna system is grounded so as to provide some protection against voltage surges and built-up static charges.

Article 810 of the National Electrical Code, ANSI/NFPA 70, provides information with regard to proper grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding conductors, location of antenna-discharge unit, connection to grounding electrodes, and requirements for the grounding electrode.

EXAMPLE OF ANTENNA GROUNDING AS PER NATIONAL ELECTRICAL CODE, ANSI/NFPA 70

 

 

ANTENNA

 

 

LEAD IN WIRE

 

GROUND

ANTENNA

 

CLAMP

 

DISCHARGE UNIT

 

 

 

 

(NEC SECTION 810-20)

ELECTRIC

 

 

SERVICE

 

GROUNDING

EQUIPMENT

 

CONDUCTORS

(NEC SECTION 810-21)

GROUND CLAMPS

POWER SERVICE GROUNDING ELECTRODE SYSTEM

(NEC ART 250, PART H)

NEC — NATIONAL ELECTRICAL CODE

• Turn off the main power and unplug the AC cord from the wall outlet before handling.

• Use a soft cloth and gently wipe the surface of the display panel. Using a hard cloth may scratch the panel surface.

• Use a soft damp cloth to gently wipe the panel when it is really dirty. (It may scratch the panel surface when wiped strongly.)

If the panel is dusty, use an anti-static brush, which is commercially available, to clean it.

To protect the panel, do not use a dirty cloth, liquid cleaners or chemical cloth to clean it, such materials may damage the panel surface.

To clean the outer cabinet, use the same method. Do not use liquid or aerosol cleaners.

Water and Moisture — Do not use this product near water - for example, near a bath tub, wash bowl, kitchen sink, or laundry tub; in a wet basement; or near a swimming pool; and the like.

Stand — Do not place the product on an unstable cart, stand, tripod or table. Placing the product on an unstable base can cause the product to fall, resulting in serious personal injuries as well as damage to the product. Use only a cart, stand, tripod, bracket or table recommended by the manufacturer or sold with the product. When mounting the product on a wall, be sure to follow the manufacturer's instructions. Use only the mounting hardware recommended by the manufacturer.

Selecting the location — Select a place with no direct sunlight and good ventilation.

Ventilation — The vents and other openings in the cabinet are designed for ventilation. Do not cover or block these vents and openings since insuffi cient ventilation can cause overheating and/or shorten the life of the product. Do not place the product on a bed, sofa, rug or other similar surface, since they can block ventilation openings. This product is not designed for built-in installation; do not place the product in an enclosed place such as a bookcase or rack, unless proper ventilation is provided or the manufacturer's instructions are followed.

The Liquid Crystal panel used in this product is made of glass. Therefore, it can break when the product is dropped or applied with impact. Be careful not to be injured by broken glass pieces in case the panel breaks.

Heat — The product should be situated away from heat sources such as radiators, heat registers, stoves, or other products (including amplifi ers) that produce heat.

The Liquid Crystal panel is a very high technology product with 2,073,600 pixels, giving you fi ne picture details. Occasionally, a few non-active pixels may appear on the screen as a fi xed point of blue, green or red. Please note that this does not affect the performance of your product.

Lightning — For added protection for this television equipment during a lightning storm, or when it is left unattended and unused for long periods of time, unplug it from the wall outlet and disconnect the antenna. This will prevent damage to the equipment due to lightning and power-line surges.

Power Lines — An outside antenna system should not be located in the vicinity of overhead power lines or other electric light or power circuits, or where it can fall into such power lines or circuits. When installing an outside antenna system, extreme care should be taken to keep from touching such power lines or circuits as contact with them might be fatal.

To prevent fi re, never place any type of candle or fl ames on the top or near the TV set.

To prevent fi re or shock hazard, do not place the AC cord under the TV set or other heavy items.

Do not display a still picture for a long time, as this could cause an afterimage to remain.

• To prevent fi re or shock hazard, do not expose this product to dripping or splashing. No objects fi lled with liquids, such as vases, should be placed on the product.

Do not insert foreign objects into the product. Inserting objects in the air vents or other openings may result in fi re or electric shock. Exercise special caution when using the product around children.

Precautions when transporting the TV

When transporting the TV, never carry it by holding or otherwise putting pressure onto the display. Be sure to always carry the TV by two people holding it with two hands — one hand on each side of the TV.

4

Image 6
Contents LC-42BD80U LC-46BD80U LC-52BD80U Imprimé au Mexique Impreso en México09P02-MX-NM Dimensional Drawings LC-52BD80UModel No To aid reporting in case of loss or theft, please recordTrademarks Declaration of ConformityAdditional Safety Information Dear Sharp CustomerPrecautions when transporting the TV Issue Tune Into SafetyThis Manufacturer Cares Cable clamp g1 Supplied AccessoriesAttaching the Stand Cable tie g1 Always use the AC cord supplied with the TVUsing the Remote Control Unit Power indicator on the front of the television lights GreenClose the battery cover Installing Batteries in the Remote Control UnitConnecting Antenna Cable PreparationContents TV Side Part NamesTV Front ButtonTV Side/Rear Part NamesInput 5 terminal Hdmi Remote Control Unit When using the remote control unit, point it at the TVWhen using composite cable Input 1 or Connecting to External EquipmentConnecting Audiovisual Equipment When using component cable Input 1 orConnecting a PC Using Digital Audio OutputConnecting Hdmi Equipment Connecting to External EquipmentTurning On/Off the Power Initial SetupWatching TV Direct Button Operation Changing VolumeSleep Timer Changing ChannelsMTS/SAP stereo mode Digital broadcasting audio modeDirect Button Operation This will present the Closed Caption information display Press Power SavingClosed Captions and Digital Closed Captions ExampleYou can select the screen size Press View ModeFor PC input mode For 43 programsTypes of Discs that Can Be Used with This TV About DiscsBlu-ray Disc Discs that Cannot Be Used with This TVAbout Discs Title, Chapter and TrackIcons Used on DVD-VIDEO Disc Cases DTSDisc Precautions CopyrightRemoving a Disc Disc PlaybackLoading a Disc BD/DVD-VIDEO PlaybackBD/DVD Menus Using the Disc MenuUsing the Pop-up Menu Disc PlaybackPlayback by Selecting a Playlist DVD-R/-RW/BD-RE/-R PlaybackVirtual Package Press Hto stop playbackAudio CD Playback Playback FunctionsPartial Repeat Playback Repeat Playback A Specified Part To cancel Repeat PlaybackRepeat Playback of a Title or Chapter Press Disc MenuDisplaying the Audio Information Switching SubtitlesSwitching the Angle Displaying the Angle MarkDisc Menu Control Settings During PlaybackDisc Menu Operation Procedure Disc Menu Which Can Be SetOn-Screen Display Menu For TV/Blu-ray/INPUT 1/2/3 ModeFor HDMI/PC-IN Mode Menu ItemsOn-Screen Display Menu On-Screen Display Menu OperationMenu Operation Buttons Lcfont embeddedOPC Setting Advanced Picture SettingPicture Menu Audio Menu SurroundBass Enhancer Power Saving Power Control MenuNo Signal Off Blu-ray disc EcologySetup Menu Fine Sync Auto Sync For Analog PC Input Mode OnlyReset PositionParental Ctrl Parental Control Setting TV Parental Guidelines When setting an individual content-based rating itemMpaa Voluntary movie rating system RatingCanadian French Ratings How to temporarily release the V-CHIP BlockCanadian English Ratings Reactivating the temporarily released V-CHIP BlockOption Menu Demo Mode Caption SetupFavorite CH Favorite Channel Setting Output SelectBlu-ray disc Setup Next generation Audio formatsBitstream USB Memory Management Software UpdateVersion Press c/d to select Yes, and then pressPress Enter to start checking data in the USB memory device Press a/b to select Software Update, and then press EnterEnter the 4-digit number by using During the data checking, Checking blinksSoftware Update Digital Setup MenuAudio Setup IdentificationAfter the screen shown below is displayed, press Presetting Remote Control Function Presetting manufacturer codesOther Viewing Options Other Viewing Options Manufacturer codes Using Aquos Link Controlling Hdmi Equipment Using Aquos LinkUsing Aquos Link Aquos Link SetupOne Touch Recording One Touch Playback Timer RecordingAquos Link Menu Press d to start playing back a titleSound mode changes each time you press Enter Playback of Titles Using Aquos LinkManually Changing Aquos Audio Speaker System’s Sound Mode Selecting Media Type for CEC-Compatible RecorderSetting the TV on the Wall AppendixRemoving the Stand Error message about reception of broadcast TroubleshootingTroubleshooting-Digital Broadcasting AppendixTroubleshooting-Disc Playback Remote control unit Still image playback or frameRS-232C Port Specifications Model LC-42BD80U Model LC-46BD80U Model LC-52BD80U Optional AccessorySpecifications Part name Model numberSecret number is PC Compatibility ChartInformation on the Software License for This Product Clearing the Secret NumberCalling for Service Limited Warranty