Connecting the LCD TV to a, Switching On/Off

Connecting the LCD TV to a

For displaying your computer’s screen image on your LCD TV, you can connect your computer to the TV set. Power off both computer and display before making any connections. Use 15-pin D-sub display cable to connect a PC to the LCD TV. When the connection is made, switch to PC source. See “Input selection” section. Set the resolution that suits your viewing requirements. Resolution information can be found in the appendix parts.

PC VGA Cable (Not supplied)

PC Input

(back)

PC Audio Cable (Not supplied)

. Side AV Input

Using Side AV Connectors

You can connect a range of optional equipment to your LCD TV.

•For connecting a camcorder, connect to the VIDEO IN socket and the AUDIO SOCKETS. For selecting the related source, see the section “Input selection” in the following parts.

•To listen the TV sound from headphones, connect to the HEADPHONE jack of theTV.

AVCable (notsupplied)

Camera

Headphone

Remote Control Handset

Inserting Batteries

•Remove the battery cover located on the back of the handset by gently pulling backwards from the indicated part.

•Insert two AAA/R3 or equivalent type batteries inside. Observe the correct polarity (+/-) when inserting batteries and replace the battery cover.

Note: Remove the battery from remote control handset when it is not to be used for a long period. Otherwise it can be damaged due to any leakage of batteries. Remote range is approximately 7m/23ft.

Switching On/Off

To Switch the TV On

Connect the power cord to the 220-240V AC 50 Hz.

•Switch the “” button on the bottom right hand side under the screen to position “” so the TV will switch to standby mode. Then the standby LED lights up.

•To switch on the TV from standby mode either:

•Press the “” button, CH / CH or a numeric button on the remote control.

•Press the “” or +/- button on the TV.

•The TV will then switch on.

Note: If you switch on your TV via CH / CH buttons on the remote control or on the TV set, the programme that you were watching last will be reselected.

By either method the TV will switch on.

To Switch the TV to Standby

To switch the TV to low power stand by press the

“” button on the remote control or right hand side of the TV.

Note: When the TV is switched to standby mode, standby LED can blink to indicate that features such as Standby Search, Over Air Download or Timer is active.

To Switch the TV Off

•Switch the “” button on the bottom right hand side under the screen to position 2 as illustrated,

to isolate the TV from the mains, the LED will go out.

•If the TV will not be used for a long period i.e. holidays, then unplug the power cord from the mains socket.

English - 13 -

A01_MB60_[GB]_1910UK_IDTV_TC_PVR_NICKEL16_40883W_YPBPR	_	ROCKER_10073202_50190040.indd 13	09.09.2011 14:31:22