Sharp LC-42D83X LC-46D83X LC-52D83X operation manual Supplying electric power to the antenna

Preparation

Supplying electric power to the antenna

When you set-up the DTV antenna for the fi rst time, or connect the antenna to a community antenna, you need to proceed to set the antenna by following this manual.

1Press MENU and the MENU screen displays.

2Press c/d to select “Setup”.

3Press a/b to select “Antenna Setup- DIGITAL” and then press ENTER.

4Press a/b to select “Supply Voltage” and then press ENTER.

5Press c/d to select “On” and then press

ENTER.

Selected item	Description
On	Select “On” when your antenna is set-up
	and connected independently.
Off	Select “Off” when you do not need to
	supply voltage to your antenna, i.e. when
	your antenna is connected to a community
	antenna. (The factory default setting of this
	function is “Off”.)

Initial auto installation

When the TV powers on for the fi rst time after purchase, the initial auto installation wizard appears. Follow the menus and make the necessary settings one after another.

Confirm the following before turning on the power

•Is the antenna cable connected?

•Is the AC cord plugged in?

1 Press POWER on the TV.

• The initial auto installation wizard appears.

2Setting the on-screen display language.

English

3Press a/b to select the desired language, and then press ENTER.

4Press ENTER.

Major Analogue Channel settings are pre-set. However, if there are any channel(s) that you cannot receive with the factory pre-sets, please perform “Auto Installation” in “Setup” section (refer chapter “Watching TV” on manual).

Digital Search

•Major Analogue Channel settings are pre-set. However, if there are any channel(s) that you cannot receive with the factory pre-sets, please perform “Auto Installation” in “Setup” section (See page 20).

5The TV searches for, sorts and stores all the receivable TV stations according to their settings and the connected antenna.

•To abort the initial auto installation in progress, press END.

NOTE

•If you turn off the power on the TV after performing step 4, the initial auto installation wizard does not appear. The auto installation function allows you to execute the installation again from the Setup menu. (Page 20)

•The initial auto installation wizard will go off if you leave the TV unattended for 30 minutes before searching for channels in step 5.

11

52D83X_en_b.indd 11

2007/08/31 16:24:50