Sharp LC-60LE822E Satellite setting, Buttons for Manual adjust operation, Cable

Basic adjustment

EManual adjust

Configure various settings for each service using the colour (R/G/Y/B) buttons.

Service	Service	Lock	CH skip	Old LCN
no.	name

Lock CH skip Delete Sort

1Press a/bto select the desired service.

2Press the colour button on the remote control unit corresponding with the item you want to reconfigure.

•The 4 mark indicates the operation is set to on. Each time the colour button is pressed, you can switch the corresponding operation on/off.

Buttons for “Manual adjust” operation

Lock Press R button.

When the service is locked, you must enter your PIN whenever you tune to the service.

CH skip Press G button.

Services with a 4 mark are passed over when pressing :R/Son the TV or remote control unit.

Delete Press Y button.

The selected service is deleted. If you want to watch the service you deleted once again, perform “Auto installation”, “Additional search”, or “Manual search”.

Sort Press B button.

The item position of services can be sorted.

1Press a/bto select the service whose item position you want to move, and then press ;.

2Press a/bto move it to the desired position, and then press ;.

3Repeat steps 1 and 2 until all desired service items are sorted.

Cable

You can reconfigure the following settings when you select “Cable” in the initial auto installation or the “Auto installation” menu.

EAdditional search

Use this menu to add new services automatically after “Digital search” in the “Auto installation” menu has been completed. Follow steps 1to 5in Searching for cable broadcasts on page 12.

EManual search

Add new services within a specified frequency band. After setting the items on the following screen, the TV starts searching.

•Refer to the table about menu items in the right column on page 12.

Frequency

Symbol rate

MHz

QAM modulation

Search start

EManual adjust

This function is the same as in “Terrestrial”. Refer to “Manual adjust” in “Terrestrial”.

H

•You can only reconfigure the “Manual adjust” settings.

•You can only set the “Lock” setting in “Manual adjust”.

Satellite setting

Before selecting the type of search in “Satellite setting”, you need to select the satellite broadcast.

SAT2 [Hot Bird 13E]

SAT3 [None]

SAT4 [Turksat]

EAdditional search

Use this menu to add new services automatically after auto installation has been completed. Follow steps 1 to 6 in the right column on page 13.

EManual search

Add new services within a specified frequency band. After setting the items on the following screen, select “Yes” from “Search start” menu.

Band	[Vert/Low]
Frequency		Vert/Low
Symbol rate
Search start		Vert/High
		Horiz/Low
		Horiz/High

EManual adjust

This function is the same as in “Digital setting”. Refer to “Manual adjust” in “Digital setting”.

33