Sharp LC-20SH4X operation manual Basic Operation, Sound Volume Changing Channels

	Basic Operation (Continued)
Sound Volume	Changing Channels
■ To adjust the volume	You can select channels using Channel Select or CH ( )/( ).

●Press VOL (+) to increase the sound volume. The numerical value increases.

VOLUME

50

•To handle the increasing number of channels available, this LCD TV set allows you to select up to 100 positions (Channels 0 to 99). One-digit and two-digit methods of selection can be used. Follow the procedure shown below to select channels.

● Press VOL (–)to decrease the sound volume.	■ Using Channel Select
The numerical value decreases.	To select a one-digit channel (e.g., Channel 5):

VOLUME	1 Press 5 of Channel Select.
10

■To mute the sound

●Press e (Mute) to temporarily turn off the sound. The MUTE mark is displayed on the screen.

●Press e (Mute) or VOL (+)/(–)to turn the sound back to the previous level. MUTE is automatically cleared when one of the following buttons is pressed: POWER,

VOL (+)/(–) or e (Mute).

VOLUME

10

2 If “5--” is indicated and the picture does not change, press -/--to switch over to the 1-digit select mode and press 5 of Channel Select.

5

PAL

B/G

To select a two-digit channel (e.g., Channel 15):

1 Press -/--to set the 2-digit select mode.

--

2 Press 1 of Channel Select.

1-

3 Press 5 of Channel Select.

15

PAL

B/G

NOTE

•Complete this procedure within 4 seconds, otherwise the selection will not be made.

Changing channels with CH ( )/( ) on the remote control.

Press CH ( ) and the channels change in the order shown below: 1 → 2 → 3 → . . . → 98 → 99 → 0 → 1 → 2 → 3 → . . .

Press CH ( ) and the channels change in the order shown below: 3 → 2 → 1 → 0 → 99 → 98 → . . . → 3 → 2 → 1 → . . .

■Using A (Flashback)

●Press A to switch the currently tuned channel to the previously tuned channel.

●Press A again to switch back to the currently tuned channel.

9