Watching TV
Power Management
You can set the TV to automatically power off when no image is displayed on PC.
1Press MENU and the MENU screen displays.
2Press c/d to select “Power Control”, and then press ENTER.
• Power control menu displays.
3Press a/b to select “Power Management”, and then press ENTER.
4Press a/b to select “Mode1” or “Mode2”, and then press ENTER.
Off
Mode1
Mode2
Selected item | Description |
|
|
Off | • No power management |
| • Factory preset value. |
|
|
Mode1 | • If no signal inputs for approximately 8 |
| minutes, the power shuts down. |
| • Even if you start using the PC and the |
| signal inputs again, the TV stays off. |
| • The TV turns on again by pressing |
| POWER. (See page 13.) |
|
|
Mode2 | • If no signal inputs for approximately 8 |
| seconds, the power shuts down. |
| • When you start using the PC and the |
| signal inputs again, the TV turns on. |
| • The TV turns on again by pressing |
| POWER. (See page 13.) |
|
|
NOTE
•If you turn off the power by disconnecting AC cord when setting “Mode2” in power management, the TV may not function properly after turning the power on again. In such case, press POWER on the remote control unit.
•Pressing POWER on the TV will have the same result.
26