Sharp LC-19A35X-BK Connecting a PC Adjusting the PC image automatically, Clock, Phase

Connecting a PC

Adjusting the PC image automatically Adjusting the PC image manually

This function enables the screen to be automatically adjusted to its best possible condition when the analogue terminals of the TV and PC are connected with a commercially available RGB cable, etc.

1Press MENU and the MENU screen displays.

2Press c/d to select “Setup”.

3Press a/b to select “PC Setup”, and then press ENTER.

4Press a/b to select “Auto Sync.”, and then press ENTER.

5Press a/b to select “Yes”, and then press

ENTER.

• Auto Sync. starts.

MENU [Setup ... PC Setup]

Input Signal
Auto Sync.	Yes
Fine Sync.	No

NOTE

•Auto Sync. is likely to succeed when an input PC image has wide vertical stripes (e.g. pattern with high contrast stripes, or cross-hatched).

It may fail when an input PC image is solid (low contrast).

•Be sure to connect the PC to the TV and switch it on before starting Auto Sync.

Ordinarily you can easily adjust the picture as necessary to change image position using Auto Sync. In some cases, however, manual adjustment is needed to optimise the image.

1Press MENU and the MENU screen displays.

2Press c/d to select “Setup”.

3Press a/b to select “PC Setup”, and then press ENTER.

4Press a/b to select “Fine Sync.”, and then press ENTER.

Press a/b to select “Yes”, and then press

5ENTER.

6Press a/b to select a specifi c adjustment item among “H-Position”, “V-Position”, “Clock” and “Phase”.

H-Position	[ 90]	a	b
V-Position	[ 60]	a	b
Clock	[ 90]	a	b
Phase	[ 8]	a	b
Reset

Selected item	Description
H-Position	Centres the image by moving it to the left
	or right.
V-Position	Centres the image by moving it up or
	down.
Clock	Adjusts when the image fl ickers with
	vertical stripes.
Phase	Adjusts when characters have low
	contrast or when the image fl ickers.

7Press c/d to adjust the item to your desired position.

NOTE

•For resetting all adjustment items to the factory preset values, press a/b to select “Reset”, and then press

ENTER.

•Images may not be displayed properly depending on the settings and/or input signals.

39