Technika LCD32-909V manual Inserting Batteries Remote Control Handset, Switching the TV On/Off

Inserting Batteries in the

Remote Control Handset

•Remove the battery cover located on the back of the handset by gently pulling backwards from the indicated part.

•Insert two AAA/R3 or equivalent type batteries inside. Place the batteries in the right directions and replace the battery cover.

Note: Remove the battery from remote control handset when it is not to be used for a long period. Otherwise it can be damaged due to any leakage of batteries.

Operating Range for the

Remote Control

•Point the top of the remote control toward the LCD TV’s remote sensor LED while pressing a button.

30 30

EPG

SCREEN LANG SUBTITLE SLEEP

ABC	DEF		GHI
1	2		3
JKL	MNO		PQR
4	5		6
STU	VWX		YZ
7	8		9
FAV	0
	V
	P
PRESET	SOURCE	IN	FO/
P			RE
SWA			T
			URN
	OK
M

Remote range is approximately 7m/23ft.

English

Switching the TV On/Off

To Switch the TV On

•Connect the power cord to the 220-240V AC 50 Hz.

•Press STANDBY switch. Then the standby LED lights up.

•To switch on the TV from standby mode either:

•Press the “” button, P+ / P- or a numeric button on the remote control.

•Press the -P/CHor P/CH+ button on the TV. The TV will then switch on.

Note: If you switch on your TV via PROGRAMME UP/DOWN buttons on the remote control or on the TV set, the programme that you were watching last will be reselected.

By either method the TV will switch on.

To Switch the TV Off

•Press the “” button on the remote control or press the STANDBY switch, so the TV will switch to standby mode.

•To power down the TV completely, unplug the power cord from the mains socket.

Note: When the TV is switched to standby mode, standby LED can blink to indicate that features such as Standby Search, Over Air Download or Timer is active.

- 17 -

MB35_[GB]_SSM_32882W_1810UK_IDTV-PANEU_BRONZE2_10063798 _ 50153877.indd 17 24.08.2009 08:47:20