Closed Caption System

You can view specially labeled (cc) TV programs, movies, news and pre-recorded tapes with either a dialogue caption or text display.

CAPTION mode: You can watch dramas, movies and news while captioning the dialogues and the contents of news.

TEXT mode: You can watch half screen text informa- tion if you want.

1-2:You may get these captions or text information by selecting either “1” or “2”. Caption “2” is usually used for a second language if available.

NOTE

•Not all programs are broadcast with closed cap- tions. Your unit is designed to provide error-free closed captions from high quality antenna, cable and VCR signals. Conversely, poor quality sig- nals are likely to result in caption errors or no captions at all. Common signal conditions which may cause caption errors are listed below:

–Automobile ignition noise

–Electric motor brush noise

–Weak snowy reception on TV screen

–Multiplex signal reception displaying picture ghosts or airplane flutter

•If the unit displays a black box on the TV screen, this means that the unit is set to the TEXT mode. To clear screen, select

“CAPTION1”, “CAPTION2” or “OFF”.

1 Press [SETUP] then press [K] or [L] to point to “CAPTION”.

	- TV SET UP -
SETUP	CHANNEL SET UP
	V-CHIP SET UP
	LANGUAGE	[ENGLISH]
	B CAPTION	[OFF]
	BACK LIGHT [BRIGHT]

2 Press [ENTER] repeatedly to select the desired caption menu “CAPTION1”, “CAPTION2”, “TEXT1” or “TEXT2”.

- TV SET UP -

CHANNEL SET UP

V-CHIP SET UP

ENTERLANGUAGE [ENGLISH]

B CAPTION [CAPTION1]

BACK LIGHT [BRIGHT]

•If you select “OFF”, Closed Caption System set- ting is canceled.

3 Press [SETUP] to exit the menu.

SETUP

NOTE

•Even if there is a power failure of any kind, the unit will retain its memory for this feature.

MTS (Multi-Channel Television

Sound) System

TO SELECT TV SOUND MODE

1 Press [AUDIO] repeatedly to select the MTS output mode.

AUDIO

STEREO

•The output mode changes as described below every time you press [AUDIO].

STEREO

SAP*

MONO

*Second Audio Program (SAP):

Sometimes broadcasters add another channel of audio to the programs they air. This is usually a secondary language or perhaps a radio station.

•After 5 seconds, the current audio status will disappear from the TV screen.

NOTE

•The initial setting is “STEREO”.

•This setting is saved even if the unit is turned off or the AC cord is unplugged.

TO CHECK THE SOUND STATUS

By pressing [DISPLAY], the status shown below will appear on the display when you receive a broad- cast on the unit tuner channel you are watching.

CH 123

STEREO/SAP 3)

1)When a program is broadcast in stereo, “STEREO” appears on the TV screen.

2)When a program is broadcast in second audio, “SAP” appears on the TV screen.

3)When a program broadcast both in stereo and sec- ond audio, “STEREO/SAP” appears on the TV screen.

- 14 -