References
Trouble Checks
You may have problems that can Look for the type of problem you suggestions to get your TV going
be fixed with a few mino_ adjustments. are having below and then try the again.
Trouble
Power
TV will not turn on
No picture, no sound but TV has power
Remote
Buttons don't work when
you press them
Works part or none of the time
Can't select certain channel
Remote Lockup
Checks and Adjustments
Plug TV in.
Plug something else into the outlet to make sure it is working. Make sure batteries in the remote are not dead.
Aim the remote at the TV and press TV.
Make sure batteries are placed in the remote the right way. See batteries on page 2.
Unplug TV for a few minutes and then turn it on again.
Check antenna connections.
Check position of Cable/Air feature. See page 24.
Try another channel. Inactive channel may be tuned.
Make sure component connected to the VIDEO INPUT jacks is turned on if you choose channel 00.
Make sure TV is tuned to the same channel as the switch on back of VCR if watching a VCR.
Make sure TV/VCR button on VCR is in correct position when using VCR.
Press TV to set the remote to control the TV. See buttons on page
Clear the path between the remote and TV of any objects. Aim the remote at the component you are trying to control. Press TV so remote will control TV.
Make sure batteries in the remote are not dead.
See if batteries are placed in remote correctly. See batteries, page 2.
Press number buttons. Channel may not be in memory. See Autoprogram on page 19.
Make sure TV/VCR switch on VCR is in the TV position.
For numbers over 100, press and hold 1 until
Set Cable/Air feature to Cable for channels higher than 69. See page 24.
Remove batteries and hold down one or more buttons for several seconds
to drain the microprocessor inside the remote and reset it.
27