Sansui SLED3280 Using an AV Amplifier with built-in digital surround, To return to normal mode

Connections to other equipment (continued)

Using an AV Amplifier with built-in digital surround

If you are using an Amplifier with built-in digital surround sound, you can enjoy various audio systems including Dolby Digital Surround audio that sounds just like the movie.

Connect an AV amplifier with built-in Dolby Digital decoder, etc. as shown below.

Front

Rear of the unitSubwoofer Speaker (Right)

ENGLISH

Front

Speaker

(Left)

To DIGITAL AUDIO COAXIAL OUT Coaxial digital cable (not supplied)

TV

To Coaxial		Center Speaker
Digital Audio IN
	Surround	Surround
AV Amplifier with built-in digital surround	Speaker (Left)	Speaker
		(Right)
decoder as listed above

NOTE:

• When you are viewing digital broadcast, this unit will not work in conjunction with DTS audio or MPEG audio. There will be no sound output if connected to an AV amplifier with a built-in DTS decoder or MPEG decoder.

To connect the TV to a PC (Personal Computer)

Before you connect this TV to your PC, change the adjustment of your PC’s Resolution and Refresh rate (60 Hz).

Connect one end of a (male to male) VGA cable to the video card of the computer and the other end to the VGA connector PC MONITOR on the rear of the TV. Attach the connectors firmly with the screws on the plug. In case of a Multimedia computer, connect the audio cord to the audio output of your Multimedia computer and to the AUDIO connector of the PC/DVI AUDIO IN jack of the TV.You can also connect the PC with HDMI cable. If you use HDMI cable, you don’t have to connect the audio cord. If you use DVI-to-HDMI cable, please connect audio cord as same way as VGA cable.

Press INPUT SELECT on the remote control to select PC mode.

Switch on the computer. The TV can operate as the computer monitor.

Rear of the unit

		Monitor Display modes
		MODE	Resolution	Refresh rate
		VGA	640x480	60/ 72/ 75 Hz
		VGA	720x400	70Hz
		SVGA	800x600	56/ 60/ 72/ 75 Hz
		XGA	1024x768	60/ 70/ 75 Hz
	To PC	WXGA	1280x768	60Hz
		WXGA	1280x720	60Hz
	MONITOR	WXGA	1360x768	60Hz
To PC/DVI	IN
	VGA cable (not supplied)	SXGA	1280x1024	60Hz
AUDIO IN		WXGA+ 1440x900		60Hz
To HDMI IN	Audio cord (not supplied)	FHD	1920x1080	60Hz
		To return to normal mode
	HDMI cable (not supplied)
		Press INPUT SELECT again.

NOTE:
•	The on-screen displays will have a different appearance in PC mode than in TV mode.
•	If there is no video signal from the PC when the unit is in PC mode, “No signal” will appear on the TV-screen. 13