RCA CRT Television manual Labeling TH E Channels, Programming TH E Remote

LABELING TH E CHANNELS

This last step in the interactive Setup lets you edit your channel list and label your channels. (For more, see List and Labels in the Using the Menu System section.)

1.Press MENU or OK to bring up the List and Labels control panel.

Use the CH ^ (channel up) or CH v

(channel down) buttons to change channels in the Chan # field. This works

even if you're not in the Chan # field. Or,

enter the channel number directly using the number buttons on the universal

remote. To enter a number greater than 99, press and hold "1" to enter the hundreds digit, then press the two remaining numbers.

The list and labels feature can also be accessed from the Channel menu. Because this procedure can be time consuming,

feel free to skip this step and come back to it later.

2_ Use the left and right arrows to point to the three different areas of the control panel (called "fields").

3.Use the up and down arrows to scroll through the numbers and letters and select Yes or No in the Normal List field. You may wish to refer to the call letters listed in your newspaper's TV section for ideas on labeling the channels.

4_ Repeat this process for each of your channels. Then press MENU or OK to continue. The TV can store up to 27 labels in memory.

PROGRAMMING TH E REMOTE

Since you've gone this far, you can take a few minutes to program the remote to control your VCR, satellite receiver, or other components. To find out how to program the remote, go to the next section.

2O