Sylvania 6519VD Preparation for USE, ANTENNA/CABLE Connections, VHF/UHF Combined Antenna

PREPARATION FOR USE

ANTENNA/CABLE CONNECTIONS

Satellite Box or
Cable Box	OUT
(Not supplied)	IN

From

Cable System

75-ohm Coaxial	or
Cable (Not supplied)

Note to CATV system installer:

VHF/UHF Antenna

From Cable System or (Not supplied) Satellite Dish

VHF Antenna (Not supplied)

UHF Antenna (Not supplied)

VHF/UHF or Combiner

(Not supplied)

ANT.

Flat twin-lead cable	[Fig. 4]
or

This reminder is provided to call the CATV system installer’s attention to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building as close to the point of cable entry as practical.

NOTE:

Before plugging the an antenna into the ANT. IN jack of the TV/DVD, check that the pin is not bent. If it is bent, straighten the pin as illustrated, then plug the pin into the ANT. IN jack of the TV/DVD.

Bent pin

Cable Plug

(Needs to be straightened)(Straight pin)

VHF/UHF COMBINED ANTENNA

A VHF UHF 75 ohm combination antenna can be connected to ANT terminal.

VHF/UHF SEPARATE ANTENNAS

In some areas it will be necessary to use an outdoor antenna.

CABLE WITHOUT CONVERTER/ DESCRAMBLER BOX

Use this connection if your cable system connects directly to your TV/DVD without a converter box. Use the TV/ DVD Remote Control to select channels.

CABLE WITH CONVERTER/DESCRAM- BLER BOX OR SATELLITE BOX

If your cable service supplies you with a converter box or if you use a satellite system, you can use the basic connection shown here.

Channel selection must be made with the converter box or satellite box. This means that channels cannot be changed using the TV/ DVD Remote Control.

TO VIEW A SCRAMBLED/UNSCRAMBLED CHANNEL

1.Set the TV/DVD channel selector to the output channel of the Cable Converter Box or Satellite Box. (Ex. CH3)

2.Select the channel to view at your Cable Converter Box or Satellite Box.

– 10 – EN

0C28