![](/images/new-backgrounds/1279481/27948123x1.webp)
CHANNEL SET UP
AUTO CHANNEL PROGRAMMING
As the initial setting, this unit has memorized all channels, including the ones not available in your area. This feature automatically puts only available channels into the memory.
1 Press [SETUP] then press [K] or [L] to point to “CHANNEL SET UP”.
- TV SET UP -
B CHANNEL SET UP
SETUPV-CHIP SET UP
LANGUAGE [ENGLISH]
CAPTION [OFF]
BACK LIGHT [BRIGHT]
2 Press [ENTER] then press [K] or [L] to point to “AUTO PRESET CH”.
ADDING/DELETING CHANNELS
The channels you no longer receive or seldom watch can be deleted from the memory. (Of course, you can add the deleted channel into the memory again.)
1 Press [SETUP] then press [K] or [L] to point to “CHANNEL SET UP”.
| - TV SET UP - | |
SETUP | B CHANNEL SET UP | |
| LANGUAGE | [ENGLISH] |
| CAPTION | [OFF] |
| BACK LIGHT [BRIGHT] |
2 Press [ENTER] then press [K] or [L] to point to “ADD/DELETE CH”.
| – CHANNEL SET UP – |
| B ADD / DELETE CH (CATV) |
ENTER | AUTO PRESET CH |
|
ENTER
– CHANNEL SET UP –
ADD / DELETE CH (CATV) B AUTO PRESET CH
3 Press [ENTER] then press the Number but- tons or [CH. K / L] to select the desired channel number.
3 Press [ENTER].
ENTER
•The tuner scans and memorizes all the active channels in your area.
•The tuner stops on the lowest memorized channel.
NOTE
•When “AUTO PRESET CH” is activated where there is no TV signal input, “NO TV SIGNAL” will appear on the display after the completion of channel scanning.
•The unit may recognize CATV channels to be TV channels if reception condition is poor. In this case, check the antenna connection and try “AUTO PRESET CH” again when reception conditions are better.
•Auto channel programming is NOT necessary when connected to a cable box or satellite box. Just select the channel for cable box or satellite input (ex. CH3 or CH4) on the unit, then select your desired channel on the cable box or satellite box.
15
| 1 | 2 | 3 |
|
ENTER | 4 | 5 | 6 |
|
7 | 8 | 9 |
| |
|
| |||
|
|
| +100 |
|
|
| 0 | +10 | ADD/DELETE |
4 Press [ENTER] then the channel number turned to red. The channel is deleted from memory. If the channel number turned to blue, the channel is added into memory.
ENTER
•To delete another channel, repeat steps 3 to 4.
•If you press [ENTER] again, the channel is memorized again.
Added channel | : Light blue |
Deleted channel | : Light red |
|
|
5 Press [SETUP] to exit the menu.
SETUP
NOTE
•To confirm that channel(s) has(have) been deleted or added, press [CH. K / L].
EN | - 12 - |