TROUBLESHOOTING GUIDE
If the unit does not perform properly when operated as instructed in this Owner’s Manual, check the unit, con- sulting the following checklist.
PROBLEM | CORRECTIVE ACTION |
No power | • Make sure the power plug is connected to an AC outlet. |
| • Make sure the power is turned on. |
No operation by infrared remote | • Check if the power plug is connected to an AC outlet. |
control | • Check the batteries in the remote control. |
| • Aim the remote control directly at the remote sensor. If necessary, |
| remove all the obstacles between the sensor and the remote control. |
| • Refer to the infrared signal on page 34. |
| • You have to be within 23 feet (7m) of the unit. |
| • Check if the correct mode is selected. If not, switch the mode by |
| pressing [SELECT], whichever you need. |
|
|
TV Mode
Sometimes a performance problem can be easily solved by checking seemingly apparent but often overlooked possibilities. Before arranging for service, check these items. It could save your time and money.
PROBLEM | CORRECTIVE ACTION |
No picture or sound | • Make sure the AC cord is connected to an AC outlet. |
| • Check antenna connection. |
| • Press [SELECT] to select TV mode. |
| Then try other TV feature. |
| • Let the unit program its tuner memory. |
|
|
No picture or poor picture on the | • Adjust direction or replace antenna. |
unit | • Adjust picture controls. |
| • Check for broken pin of the antenna cable. |
|
|
No sound or poor sound | • Adjust volume control on remote control or main unit. |
| • Press [MUTE] to restore sound. |
Bars on screen | • If outside antenna is being used, check for broken wire. |
| • Check for local interference. |
Picture distorted or blurred | • Try a new channel, if OK, then possible station trouble. |
| • If outside antenna is being used, check for broken wire. |
Picture rolls vertically | • Try a new channel, if OK, then possible station trouble. |
Lines or streaks in picture | • If outside antenna is being used, check for broken wire. |
| • Check for local interference. |
No color | • Try a new channel, if OK, then possible station trouble. |
| • Is antenna connected to jack on the back of the set? |
| • If outside antenna is being used, check for broken wire. |
| • Adjust “COLOR” control. |
Poor reception on some channels | • Try a new channel, if OK, then possible station trouble. |
Ghosts in picture | • Is antenna connected to jack on the back of the set? |
| • If outside antenna is being used, check for broken wire. |
| • Check for local interference. |
Weak picture | • Try a new channel, if OK, then possible station trouble. |
| • Is antenna connected to jack on the back of the set? |
| • If outside antenna is being used, check for broken wire. |
| • Adjust “CONTRAST” & “BRIGHTNESS” control. |
|
|
EN | – 32 – |