JVC AV 27S776, AV 32S776, AV 30W776 manual Connecting to a Digital TV Receiver

Quick Setup Connections

Connecting to a Digital TV Receiver

By connecting a Digital TV Reciever, high definition pictures can be displayed on your TV in their digital form.

DTV Decoder

DIGITAL OUT AUDIO OUT

L R

	AUDIO		AUDIO	VIDEO	S-VIDEO	COMPONENT VIDEO
75Ω	OUT	R	L		Y	Pb	Pr
(VHF/UHF)					INPUT-3
	R				INPUT-2
OPTICAL OUT					OVER
Digital	L
					INPUT-1
Audio
					OVER

HDMI to DVI Cable

After the connections have been made, tighten the screw to secure the cables.

TV Rear Panel

DIGITAL-IN

VIDEO

(DIGITAL)

AUDIO

(DIGITAL)

1)Connect the HDMI to DVI Cable from the DIGITAL OUT on the back of your DTV decoder, to the DIGITAL-IN on the back of your television.

2)Connect a red cable from the DTV decoder RIGHT AUDIO OUT, to the RIGHT AUDIO IN into VIDEO-3 on the back of your television.

3)Connect a white cable from the DTV decoder LEFT AUDIO OUT, to the LEFT AUDIO IN into VIDEO-3 on the back of your television.

•The digital-in terminal is not compatible with the picture signal of a personal computer.

•Use a HDMI to DVI cable (commercially available) in order to digitally connect the television with a DTV decoder.

Notes:

•If 480p signals (640x480 or 720x480) are displayed on the screen, the horizontal balance may be slightly shifted. Access the “DIGITAL-IN” in the initial setup menu to adjust it. (Refer to page 46.)

•When you do the above connection, set DIGITAL-IN AUDIO in the Initial Setup menu to ANALOG. See "DIGITAL-IN AUDIO", page 46.

17