JVC AV 30W776, AV 32S776, AV 27S776, AV-32S776, AV-32S766, AV-30W776, AV-27S776 manual Set Lock Code

Initial Setup

Set Lock Code

Channel guard and V-Chip settings are protected by a four-digit lock code. Your TV comes pre- set with a lock code of “0000”. You may change the code to any four-digit number you wish. To change the lock code, follow the steps below.

Press the MENU button

π† To SET LOCK CODE

è To operate (lock icon appears) Press ZERO to access the lock code

The first digit will be highlighted è To select the number

SET LOCK CODE

LOCK CODE 0000

PRESS OK TO FINISH

SELECT OPERATE MENU EXIT

π† To move to the next digit

Continue to follow these directions for all four numbers

Press the OK button to finish (your lock code is now set) Press the MENU button when finished

When a viewer attempts to watch a blocked channel, this message appears:

The channel will remain blocked until the correct lock code is entered (see above for information on setting your lock code).

THIS PROGRAMMING EXCEEDS YOUR RATING LIMITS.

PLEASE ENTER LOCK CODE BY 10 KEY PAD TO UNLOCK IT.

No. - - - -

Notes:

•After a power interruption you must reset the lock code.

•Write your lock code number down and keep it hidden from potential viewers.

•If you forget the lock code, a new code may be set using the steps listed above.

38