Setting up your TV, Connecting the aerial cable

Setting up your TV

CAUTION

•Turn off the equipment including the TV before connecting.

1Connecting the aerial cable.

(1)

VHF/UHF outdoor aerial

Matching aerial adapter (supplied)

(2)

(3)

75-ohm coaxial cable (not supplied)

If you connect a VCR, connect the aerial output jack of your VCR and the aerial jack on the TV with aerial cable. Then connect the output jacks of your VCR and the VIDEO-1 input jacks of the TV with the video cable (or S-VIDEO cable if available) and audio cables. For details, see the manual of your VCR.

2Connecting the compatible main plug to the AC outlet.

3Inserting batteries into the remote control.

Insert two batteries by following the + and - polarities

and inserting the - end ﬁrst.

CAUTION:

Follow the cautions printed on the batteries. Notes:

• Use AA/R6/UM-3 dry cell batteries.

Rear of TV

To video output

VHF/UHF outdoor aerial

29M series

VIDEO-1	COMPONENT
VIDEO-1		(VIDEO-2)	OUTPUT
INPUT		(VIDEO-2)	OUTPUT
INPUT		INPUT
S
OVER
V	Y/V		V
L/MONO CB		L/MONO	L
R	CR	R	R

To audio	To RF
output	output

• If the remote control does not work properly, ﬁt new batteries. The supplied batteries are for testing, not regular use.

4 Turn on the TV by pressing the main power button.

JVC logo appears on the screen.

To S-video
output	VCR	To aerial input
	VCR	To aerial input

The illustration shown is just a sample. It may not be same as your TV.

JVC logo will appear on the screen again at the phase of “SETUP

TOUR RESTART?” function. Then the initial setting can be

performed according to page 8.