Grundig AMIRA32HDBLK manual Start, Contents of the box, Antenna connection, Batteries

Page 6

Start

Remove your television carefully out of its box. You can keep the package of your television to use it later on.

Contents of the box

Accessory box

Power cable

Remote Control

2 batteries

Note: The Scart, , HDMI, VGA and RCA cables are not supplied with the device.

Antenna connection

If you use a coaxial cable (round cable) of 75 Ohms as an antenna cable, connect the antenna plug directly to the antenna input located on the TV.

The motorized vehicles, energy and telecommunication lines affect your antenna. Therefore, be careful about installing your antenna away from these and metal surface in such a way that it shall not swing.

Do not have your antenna cable longer than required and do not shape it in a roll. Make sure that it is not cramped while passing through a window or door.

Your antenna and cable might be affected by natural phenomena such as rain, wind, smoke and humidity over time. Check periodically your antenna and equipment.

Powering on your set and the initial use

1.Insert the power cable plug supplied with the device into the socket.

2.Insert the power cable into the power supply input located on the back panel of the LCD TV.

Note 1: Your TV will go to stand-by mode in five mimutes if there is no broadcast signal

Note 2: YourTV is equiped to oparate with TV buttons in case your R/C is broken or the batteriesare exhauseted.

3.Press the Main power on/off button

located on the LCD TV..

4.To power on your television, press

7any numerical key on the remote control or the key ““/”“.

For this process, you can also use the TV. buttons found on the panel of your television. The picture will be visualized on the screen after a while.

Note: If you are not going to use your television for a long period of time, make sure to switch it off from the power on/off button.

Initial power on and settings performance

To set up your television, read the parts on the TV controls and performance of the broadcast settings.

Batteries

Open the lid of the battery compartment and make sure you have placed the batteries in the correct direction.

For this remote control, the battery types UM-4, IEC R03 or AAA 1.5 V are suitable.

Do not throw your old batteries into the fire, discard then in the waste areas dedicated to this purpose.

Do not use the used, old batteries with new ones and different types of batteries together.

The performance of the remote control will be reduced at a distance of 8 meters from or at an angle of 30 degrees beyond the centre of the TV.

-6-

Image 6
Contents Colour Television Contents Cleaning the screen and the cabinet Important InformationDisposal Special Features Your TelevisionNetwork Supply… Air Circulation…Heat Damage… Things to be DoneStart Contents of the boxPowering on your set and the initial use Antenna connectionExternal Connections Control UnitTV Control Panel Menu buttonRemote Control Tuning and storing the programs on your television TV controlsMain Menu Manual tuning and storing of the television channels If you already know the Channel numberFine Tuning If you do not know the channel numberProgram Table Settings on your new television Setting up the Sound Menu Deleting a program that has been storedTo name the programs Picture Set up Enter the Image menu by pressingLetterbox Features149 SubtitleUsing the PIP Picture in Picture feature PIP PositionTeletext Question answer button Reveal Update ButtonSub page button SUB ClockHigh definition HD ready HeadphonesTransition to the PC mode PC ConnectionPC Accession Setting Switching to the Hdmi modeHelp and tips RF Antenna input Power supplyProgram memory Sound systemsATW.801