JVC AV 24F702 manual TV Basic Operation, Green bar. As the volume level, See to Memorize Channels

TV BASIC OPERATION

Before operate your TV select TV position of the TV/CATV switch on the remote to control the TV with the remote.

	1		To turn on the TV, press the POWER button.
2		The VOLUME can be adjusted to a desired level by
			pressing the VOL (VOLUME) + or – button.
			Adjust the volume level by
			pressing the VOLUME + or –
			button. The volume level will
			be indicated on the screen by			VOLUME	32
			green bar. As the volume level
			increases, so do the number of
			bar. If the volume decreases,
			the number of green bar also decreases.
			The sound level will be indicated on the TV screen by
			green bars and a number. As the sound level in-
			creases, so do the number of bars and the number on
			the screen. The same is true for decreasing the level.
3			Set the TV/CATV menu option to the appropriate
			position. When shipped from the factory, this menu
			option is in the CATV setting. See "TO MEMORIZE
			CHANNELS".
			TV	-	VHF/UHF channels
			CATV	-	CABLE TV channels
4		CH (CHANNEL) + and – buttons
		Press and release the CH					CH 012
		(CHANNEL) + or – button. The
		channel automatically stops at the
		next channel set into memory.

For proper operation, before selecting channels, they should be set into the TV's memory.

See "TO MEMORIZE CHANNELS".

RETURN button

Returns to the channel viewed just before the channel currently onscreen.

CH 012 CH 007

MUTING button
The MUTING button instantly turns the	MUTING
volume down completely when you
press it.

Press MUTING button and the volume level will instantly go to zero. To restore

the volume to its previous level, press MUTING button again.

10-key pad (0-9)

Press these buttons to select a channel. The channel number will appear on the upper right corner of the TV screen. If an invalid channel number is selected, the display will revert to the original channel.

TV Mode Direct Channel Selection

When the TV/CATV menu option is in the TV position, all channels can be instantly selected by using two buttons. (For example, to select channel 2, press "0", then "2". If you press only "2", channel selection will be delayed for a few seconds). For channels 10 and above, press the 2 digits in order.

CATV Mode Direct Channel Selection

When the TV/CATV menu option is in the CATV position, channels can be selected as follows:

CH. 1-9 Press "0" twice, then 1-9 as needed. Example, to select channel 2, press "002".

CH. 10-12 Press "0", then remaining 2 digits. Example, to select channel 12, press "012".

CH. 13-99 Press the 2 digits in order.

Example, to select channel 36, press "36".

CH. 100-125 Press the 3 digits in order.

Example, to select channel 120, press "120".

NOTE: If the station being viewed stops broadcasting, the TV will automatically shut off after 15 minutes.

17