Remote Control Basics, Changing the Batteries

TV	CATV VCR DVD	POWER
		POWER
		STANDARD
		INPUT

1 2 3

BBE 4 5 6

DISPLAY 7 8 9

SLEEP TIMER	0	RETURN
C.C. AUDIO SELECT		LIGHT
RM-C309G
MUTING	+	ENTER
	+
	CH
VOL	VOL
	+
	CH
MENU		EXIT
VCR CHANNEL	VCR /DVD	TV/VCR
PREV NEXT	POWER	TV/VCR

REW PLAY FF

REC STOP PAUSE

OPEN/CLOSE STILL/PAUSE

REMOTE CONTROL BASICS

•Before you can operate the remote control, you must first install the batteries (included). See “Changing the Batteries” on this page above for instructions. (For an illustration, please see page 6.)

•Press the POWER button to turn the television on or off.

•Make sure the TV/CATV switch is set to TV. Move the switch to CATV only if you need to operate a cable box.

•Slide the VCR/DVD selector switch to VCR to control a VCR, slide to DVD to control a DVD player. Please see pages 8 to 10 for instructions on programming your remote control to operate a Cable box, VCR or DVD player.

•Press the CH + and CH – buttons to scan through the channels. Tap the CH + or CH – button to move through the channels one channel at a time.

•Press VOL + or VOL – to raise or lower the volume. An indicator bar will appear onscreen to show you the television volume level.

•The CH +/– and VOL +/– buttons are also used to navigate JVC’s onscreen menu system.

•You can directly access specific channels using the 10-key pad.

•This remote includes illuminated buttons for key features like CH +/– buttons, and VOL +/– buttons. Press the LIGHT button to turn the illumination on.

CHANGING THE BATTERIES

Push down on the remote’s back cover and slide towards the bottom to remove it.

Insert two AA batteries (supplied), carefully noting the “+” and “–” markings on the batteries and on the remote control. To avoid a potential short circuit, insert the “–” end first.

Be sure to use only size AA batteries.

When batteries are installed, slide the cover back into place (until it clicks into position).

•If the remote control acts erratically, replace the batteries. Typical battery life is six months to one year. We recommend using alkaline batteries for longer battery life.

When you change the batteries, try to complete the task within three minutes. If you take longer than three minutes, the remote control codes for your VCR, DVD, and/or Cable Box may have to be reset (pages 8-10).