VTech VT181CHE-IR, VT181CH-IR manual HD15 Connector, Pin Signal

Page 7

2.5Signal Connections Cont.

Use the HD15 to DB9 video adapter cable to connect the flat panel display to the EPDG I/O adapter board.

Use the HD15 to 5BNC video adapter cable to connect the flat panel display to the original Red, Green, and Blue coax cable connected to the PDG I/O adapter board. The 2 extra BNC cables on the video adapter are not used.

Note: The following figure is the view looking into the pin end of the male connector or solder term end of the female connector.

HD15 Connector

The following table provides the pin numbers and corresponding pin assignments for the HD-15 video connector.

Pin

Signal

 

 

1Red Video

2Green Video (SOG PDG only)

3Blue Video

4Not Used

5Not Used

6Red Video Ground

7Green Video Ground

8Blue Video Ground

9Not Used

10Ground

11Ground

12Not Used

13Horizontal Sync (EPDG only)

14Vertical Sync (EPDG only)

15Not Used

HD15 Connector

Female

5

VT181CH / VT181CHE User Guide

150-066

Image 7
Contents VarTech Systems Inc Table Of Contents Introduction VT181CH Display FamilyProduct Safety Precautions VT181CH Series Display Features Display SetupUnpacking and setting up your display Signal ConnectionsPin Signal HD15 ConnectorGetting Started Adjusting the displayButton Description User Controls Geometry Menu Adjustment ProcedureColor Menu Miscellaneous Menu Touch Screen Introduction Touch ScreenTroubleshooting Tips TroubleshootingCleaning Cleaning and MaintanenceMounting Procedure Flush Mount Mounting Procedure Tray MountMounting Instructions Engineering Specifications SpecificationsVartech Systems