Section
7 |
| MOUNTING INSTRUCTIONS | |
|
| ||
|
|
|
|
Mechanical Drawings |
|
| |
|
|
|
|
Model | Description |
| Page(s) |
VT181CH/CHE | Tray Mount |
| |
|
|
|
|
VT181CH/CHE | Flush Mount |
| |
|
|
|
|
7.1Mounting Procedure - Tray Mount
1.Remove the original CRT display monitor. Keep the two "L" shaped brackets. These brackets will be used to mount the flat display.
Included with the display are a set of brackets for both upper and lower tier mounting.
2.Remove the original front console bezel and 20" curved IR touch frame.
3.Install the new replacement console bezel with the original four screws.
The new console bezel is complete with the new flat IR touch frame.
4.Connect the new touch cable per section 4.1
5.Mount the display to either the lower tier slide tray or the upper tier fixed tray using the supplied brackets. Position the display to the rear of the flat IR touch frame. For lower tier applications, replace the tray stop bolts with the longer supplied stop tubes and bolts and secure.
6.Connect the membrane extension cable to the membrane tab that projects through the console bezel.
7.Connect the video cable per section 2.5
8.Connect the power cord to the display and select the power switch to ON
9.Turn on the station main power switch and boot the system
10.Make any OSD adjustments if required per section 3.1
7.2Mounting Procedure - Flush Mount
1.Remove the original CRT display monitor.
2.Remove the original front console bezel and 20" curved IR touch frame.
3.Install the new replacement console bezel with the original four screws. The new console bezel is complete with the new flat IR touch frame.
4.Connect the new touch cable per section 4.1
5.Mount the display to the rear of the lower tier or upper tier replacement console bezel using the supplied screws.
6.Connect the membrane extension cable to the membrane tab that projects through the console bezel.
7.Connect the video cable per section 2.5
8.Connect the power cord to the display and select the power switch to ON
9.Turn on the station main power switch and boot the system
10. Make any OSD adjustments if required per section 3.1
Note:
For display upgrade only when replacing the flat screen Sony monitor, omit step 2, step 3, and step 4.
13
VT181CH / VT181CHE User Guide |