Battery charging
Once you have installed the battery, the screen indicates the battery status (see the table below). For best performance, keep the handset in the telephone base or charger when not in use. The battery is fully charged after 12 hours of continuous charging.
|
|
| Battery indicators | Battery status | Action |
| The screen is blank, or | The battery has no charge | Charge without interruption | ||
| shows Put in charger and | or very little charge. The | (at least 30 minutes). | ||
|
|
| flashes. | handset cannot be used. |
|
|
|
| |||
|
|
|
|
|
|
| The screen shows | The battery has enough | Charge without interruption | ||
| Low battery and | charge to be used for a | (at least 30 minutes). | ||
|
|
| flashes. | short time. |
|
|
|
|
| ||
|
|
|
|
|
|
| The screen shows | The battery is charged. | To keep the battery | ||
| HANDSET X. |
| charged, place it in the | ||
|
|
|
|
| telephone base or charger |
|
|
|
|
| when not in use. |
• If you place the handset in the telephone base or charger without plugging in the battery, the screen displays NO BATTERY.
Tabletop to wall mount installation
The telephone comes ready for tabletop use. Follow the steps below to mount your telephone on a wall.
. If you have already installed the telephone for tabletop use, unplug the telephone line cord from the telephone wall jack, and unplug the telephone base power adapter from the wall outlet. Remove the telephone line cord and the power adapter cord from the grooves.
2.Route the telephone line cord through the rectangular hole on the wall mount bracket and plug it into the telephone wall jack. Route the power cord out of the telephone base and plug it into an electrical outlet not controlled by a wall switch.
3.Position the lower portion grooves on the telephone base to the lower portion tabs (marked B) on the wall mount bracket. Make sure the upper portion grooves of the telephone base are above the upper portion tabs (marked A) on the wall mount bracket. Push the telephone base down until it clicks securely in place.
4.Align the holes on the bracket with the standard wall plate and slide the bracket down until it locks securely. Bundle the telephone line cord and power adapter cord neatly with twist ties.