Sceptre Technologies Sceptre X42 specifications For Analog Cable and Antenna Users, Page37

For Analog Cable and Antenna Users

Note: The following instruction set is for TV tuner antenna, analog cable users only. When using the TV for the first time, you must perform the channel scan to get all correct channels by doing the following: Press the “SOURCE AV” button on the remote controller to select the TV input signal labeled either “Cable ###” or “Air

###”. # represents numbers.

1.Press MENU button to activate the On Screen Display (OSD) menu

2.Press “VOL +/-“ button to select the “TV SETUP” function group

3.Press “CH +/-“ button to select correct “Cable/Air” signal source

4.Press “CH +/-“ button to select “CH-SCAN” function and then press “←”(button in the center of VOL +/- & CH +/-) to perform channel scanning to obtain all available channels.

For Set-top Box Users (including Digital Cable, Satellite, other video

displaying devices)

Note: The following instruction set is for set-top box users (including digital cable, satellite box, and other video devices)

1.Make sure your video cables are connected correctly to the back of the television color matching all ports.

2.Press the “SOURCE AV” or “SOURCE PC” button on the remote controller to select the TV input signal which you’ve connected the set-top box to AV1, AV2, HDMI-1(HDMI, HDCP, DVI), HDMI-2(HDMI, HDCP, DVI), VGA-PC, VGA-YPbPr2, or YPbPr1(Component).

3.Please consult your set-top box’s manual with regards on how to turn on the device and browse channels.

SCEPTRE X42 Page37