Sceptre Technologies U50 user manual Find the actual code you must read through your own

Problems	Solutions
	The TV’s tuner signal must not be lower than 65 %. Check your
	signal.
WEAK SIGNAL OR	The TV’s tuner signal must not be lower than 65 %. Change
NO PROGRAM	the direction of your antenna and rescan your channels. If you
SYMBOL ON	have cable, call up your cable company and ask about signal
SCREEN	strength of your local cable.
TV’S UNIVERSAL	This television follows SONY’s universal remote code. To
REMOTE CODE	find the actual code you must read through your own
	universal remote’s guide book.
TV CHANNELS ARE	Check your auto lock function’s settings inside the OSD. You
BLOCKED	may have locked up some channels but forgot about them.
	Refer to page 33 for more instructions.
UNIVERSAL	This TV follows SONY’s universal remote code. Please check
REMOTE CODE	your hand book for SONY’s codes then apply them.
THE TV TURNS ON	This TV is a High Definition liquid crystal display panel TV. It
OR OFF SLOWLY	requires a few more seconds than normal TVs to power up and
AND THE SCREEN	show the picture.
SHOWS UP
SLOWLY
NO SOUND ON PC	Make sure you have a 3.5 mm mini-jack cable connected from
	your pc’s sound output to the TV’s VGA STEREO INPUT.
HDCP VIDEO SAYS	Reboot your HDCP video device but turning them off and
NO HDCP SUPPORT	unplugging the power cord. Wait up to 8 minutes to plug the
	power back in to see if it works or not.
	Make sure you have a 3.5 mm mini-jack cable connected from
HDCP VIDEO HAS	your HDCP video device’s sound output to the TV’s VGA
	STEREO INPUT. If your HDCP video device uses RCA AUDIO
NO AUDIO
	jacks, you’ll need to obtain a RCA audio converted into 3.5 mm
	mini-jack cable.
CANNOT GET	VGA does not support resolution that high, only HDMI 1 does.
3840X2160 ON PC
VGA
PICTURE IS	This might be from interference from large electrical appliances,
DISTORTED OR	cars, motorcycles, or fluorescent lights. If the TV is close to the
HAS ABNORMAL	wall, try moving the TV to another room in your house to see if
SOUND	the problem still occurs.
PICTURE DOES	If you’re using HDMI or a TV digital channel make sure you use
NOT COVER THE	the ASPECT button to switch to 16:9 format. If you are using
ENTIRE SCREEN	VGA, use the AUTO ADJUST function to adjust to the screen.
	Please Note : If you are using regular analog TV, AV, or
	component in 480i resolution, use the ASPECT button to switch
	to 16:9 in order to fill up the screen. Please Note : This note
	this feature will distort the picture.

- 51 -

www.SCEPTRE.com

SCEPTRE U50 UHD TV User Manual