Installation
Important considerations: The sensor/transmitter must be mounted to the door jamb. The magnet should be attached to the door. To prevent vandalism and increase battery life, the sensor/transmitter should be installed inside.
To install the battery in the transmit- ter remove the back of the case by pushing in the tab on the bot- tom with a small screwdriver
and rotating the blade.
Install an alkaline type A23 12 Volt battery. The positive terminal should be positioned as shown.
Test the location of the sensor/transmitter. Hold the transmitter on the door jamb with one hand, and the magnet with the other as shown. Take the magnet away, and the chime should sound.
Alignment Marks
The edge of the magnet must be within 1/2" (13 mm) in. of the edge of the transmitter, the alignment marks must be positioned as shown, and the front surfaces of the magnet and transmitter should be as nearly flush with each other as possible. It may be necessary to use the spacer under the magnet to obtain the correct spacing.
Use either screws or
Attach the back of the case to the door jamb or wall. Snap the front of the transmitter and magnet back on.
When attaching the magnet or transmitter using the