Initial installation | Daily operation |
Directing DVB-T antenna
(only for
If you use a room antenna to receive one or more
To help you direct your antenna or to help you determine the most suitable loca- tion to set up the antenna, your TV set has a display for the signal quality C/N and the signal strength Level.
Consult your specialist dealer to find out which channels and frequency bands (VHF or UHF) are used to broadcast the digital TV stations in your area.
On any one channel, several digital stations are broadcast.
Select a TV channel
1. | Call the “TV menu“ via the MENU button. |
|
|
|
| |||||
2. | Use | to select “Settings“, then use | to select the menu line under- | |||||||
| neath. |
|
|
|
|
|
|
|
|
|
3. | Select “Channels“, then use | to select the menu line underneath. |
| |||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| TV menu |
|
|
|
|
|
|
|
|
|
| Settings |
|
|
|
|
|
|
|
|
|
| Channels |
|
|
|
| INFO | END |
|
|
| search | Manual settings | OK | Change |
|
| Autom | |
|
|
|
|
|
|
|
|
|
|
|
4. | Select “Manual settings“ and call the menu using OK |
| ||||||||
Switch on from stand-by
On the set:
If the LED on the set glows red or orange:
( | Press the display window to switch the set on. | |
| ||
| If the red LED on the set is not alight: | |
| Press the On / Off button (mains voltage) on the right hand | |
| side of the set. | |
| Switch to | |
( | Press the display window, the LED changes colour from green | |
to red. | ||
|
Switch on/off with the remote control
The set is on
Press the blue on/off button on the remote control to switch on the set or ...
AV
Manual settings
Signal source
Channel
Frequency
Name
C/N 96 
Antenna/cabl |
E05
177.50 MHz Test
Level 99 
Search END
StoreINFO
with a numeric key (0 – 9) or ...
wxyz
OK 
with the OK button.
The green operating LED then lights up.
5.For digital stations, select “Signal source –
6.Use the numerical buttons to specify the corresponding channel number. When you receive a digital station, the system displays the signal quality C/N via a bar/numeric value and the signal strength via Level. The anten- na‘s direction or position is best when the largest values possible are displayed (long bar) for the signal quality and signal strength.
7.Direct the antenna so that the largest numerical value/bar size is reached.
8.If no signal is found in the channel set, you can start the frequency search run by pressing the blue button within the band selected (VHF or UHF).
9.Check the other channels one after another on which digital stations are broadcast terrestrially in your area.
For the weakest station, direct the antenna so that the maximum numerical value/bar size is achieved.
10.After you position or direct the antenna, we recommend to search for all the stations using the “Search wizard“ (TV menu – Settings – Channels – Auto- matic search).
Switch on radio mode: (see also page 18).
RADIO | Press the Radio button. |
Switch off radio mode:
RADIO Press the Radio button again or ...
END | press the button END. |
11 - 