Loewe L 20 DVB-T, A 20 DVB-T Switch On/Off, Automatic programming, Channel sorting, Start with OK

Initial installation

Switch On/Off

Press the On / Off button (mains voltage) on the right hand side of the set until it locks.

The red indicator on the TV set now lights up (standby mode).

Switch on the set with the switch integrated in the display. The green indicator now lights up (other operating possibilities, see page 11).

It takes about 2 minutes after switching for the screen to reach full brightness due to the LCD technology.

If you will not be using the TV set for a long time, e.g. during a vacation, switch it off with the On/Off button (mains voltage). The set is then disconnected from the power supply.

Automatic programming

Automatic programming of the TV set is started the first time you switch it on. Follow the menus

By pressing the OK button in the direction of the arrow

OK

you select the setting ...

... and confirm your settings with OK. You then go to the next

OK menu.

Back to the previous menu.

1.First you have to select the menu language.

In models without DVB-T, please continue with step 3.

2.Press the OK button to go to the ”Signal source” menu. If you want to re-

ceive terrestrial stations	Signal source
digitally (only in DVB-T	Antenna/cable
models), select “DVB-T”,	DVB-T
confirm with the yellow	OK Proceed	Mark/unmark
colour button. If you se-		Back

lect ”Antenna/cable” as well, you can also search for and store conventional analog stations.

3.For specific national station sorting and pre-settings, enter the location at which your TV is being used.

In models without DVB-T, please continue with step 5.

4.When you have selected ”DVB-T”, you go to the ”Antenna DVB-T” menu. If you are using an active antenna, mark “yes (5V)”.

5.With OK you get an overview of which settings are to be used for the auto- matic programming.

6.Press the OK button again to start the station search. The set searches for, sorts and stores all receivable TV stations, according to your setting and the connected antenna.

7.When the TV stations are stored, an appropriate message is displayed.

8.The radio stations are then searched for with OK.

9.The TV set searches for, saves and sorts all radio stations which are receiv- able on your antenna system.

10.When the radio stations are stored, an appropriate message is displayed.

11.The station search is terminated with OK.

12.Finally log in your recorder, DVD player etc. and connect it with the TV set (also see page 21)

You can repeat initial installation at any time, e.g. after moving house.

INFO	Call the index with the INFO button.
OK	Select the index item “Repeat initial installation“.
OK	Start with OK.

Channel sorting

You can change the station sorting that was carried out automatically later at any time, see “TV menu – Settings – Channels – Change“.

- 10