Loewe 32 HD/DR+ manual Initial installation, Remote control, Connection, Switching on

Initial installation

Remote control

Batteries

To insert or change the batteries, press the point marked by an embossed arrow. Push the cover of the battery compartment down and remove it.

Insert the batteries of the alkaline manganese type LR 03 (AAA) with the correct polarity (+/Ð).

+

+

Then push the cover back on.

If the batteries are almost empty you will see the Ólow batteryÓ message on the TV screen when you operate it. The batteries must then be changed.

Note on disposal of batteries:

The original batteries do not contain any pollutants such as cadmium, lead and mercury. Used batteries do not belong in the domestic waste. They must be taken to the appropriate collec- tion points according to the na- tional laws. Ask your dealer.

Adjust the remote control for operating the TV set

TV

DVD STB

VCR Turn the rotary switch to ÓTVÓ.

See page 21 follow. for how to switch over the remote control for operating other equipment.

Connection

Mains

Connect the TV set to a 230V/50Ð60 Hertz out- let.

Antennas

Remove the rear cover from the unit by pulling it backwards. Clip the cables into the cable holders and feed them downwards, through the opening. Connect your antenna or cable system to the antenna socket of the PIP tuner.

Plug the antenna plug protruding from above the PIP tuner into the antenna socket of the VHF/ UHF tuner.

If your TV set is equipped with the terrestrial digital tuner 2 T CI or 2 S/T-CI, connect your antenna system to the top socket of the DVB-T module (IN) and connect the bottom socket (OUT) to the antenna input of the PIP tuner.

If when equipped with the terrestrial digital tuner 2 T-Basic a common antenna is used for digital and analog signals, connect the terrestrial digital tuner and the analog tuner to the antenna system via an antenna splitter.

If equipped with one or two satellite tuners, connect the SAT antennae to the SAT sockets (see figure on page 5).

Replace the cover.

						DIG IN
SAT	RC5/RC6	SERVICE				1
	IR					2
		CTRL
SAT A/D		VGA				DIG OUT
		AUDIO IN	AV1	AV2/RGB	AV3
			R
		AUDIO	OUT
	VHF/UHF		L
						SUR
					C	R
				SUBWOOFER		L
				STAND	SUB

Switching on

The display and the On/Off switch are combined in one unit.

Press the On/Off button so that it is pressed in.

Initial installation

Automatic programming of the TV set is started the first time you switch it on. Follow the menus. First you have to select the menu language for your set. Then you specify which antenna you have connected to your TV and in what country you are using it. Then you start the station search. The TV set searches for, stores and sorts all the stations which your antenna system re- ceives. You then see a list of the stored stations in which you can mark your favorites. Finally log in your video recorders, decoders, Loewe audio system and Home Automation with the connec- tion wizard and connect these to the TV set according to the illustrated connection plan.

	Pressing the OK button in the
OK	direction of the arrow to select
	the settings
	....confirm the settings with OK.
OK	You then move on to the next
	menu...
	...press this button if you
	want information about the
	settings.

You can repeat initial installation at any time, e.g. after moving house. Call the index in the main information (i button). Then select the item ÓRepeat initial installationÓ. Then start ÓInitial installationÓ with OK.

9

BAQ2550H_31310_021_4_GB 9 22.07.2004, 10:15 Uhr