4.3 Connecting and Switching On
Connecting (see the picture on page 8 for an overview of the connections)
☞Insert the mains cable into the input socket on the monitor and plug the other end into an outlet socket.
• Cable outlet or terrestrial antenna
If you have a cable outlet or a terrestrial antenna, connect it to the socket ANTENNA.
•Satellite receiver
If you have a satellite receiver, use a SCART cable to connect it to the socket SCART 1 or SCART 2.
•PC
To connect your PC to the TFT monitor, use the PC
On some older PC graphic cards, pin 9 of the connector may be blanked off. If this is the case, please contact your local dealer.
Preparation
• Remote control
☞Open the battery compartment on the back of the remote control and insert the two batteries supplied with the monitor (type LR03 Micro AAA). Observe the battery polarity shown on the bottom of the battery compart- ment. Close the battery compartment again.
Switching on
☞Set the mains switch on the back of the monitor to the position "I". The monitor is now in standby mode
and can be switched on with the remote control. |
|
| RK 14 |
• Cable outlet or terrestrial antenna |
|
| |
|
|
| |
☞ Switch on the monitor by pressing the TV key or one | TV | AV | PC |
of the numeric keys on the remote control. |
|
|
|
| F | M/S |
14