Appendix
PDP
READ CAREFULLY BEFORE INSTALLATION!
THE INSTALLATION GUIDE SHOULD BE RETAINED FOR FUTURE REFERENCE. Caution:
1.Do NOT attempt to install the TV by yourself to avoid mistakes or hazard. Refer all installation to qualified servicing personnel.
2.Do NOT install the TV on a wall aslope or a wall that makes the TV screen sloping over 25o off plumb line. Otherwise, it may cause tumble or injury.
3.Refer all installation to qualified servicing personnel.
4.One must follow the instructions in this guide to correctly install the TV.
5.It requires more than one person to install the TV.
6.Before installation, examine whether the wall conforms to the specifications and whether the supplied parts can be fixed on it. The wall for mounting should sustain the weight of TV and speakers, e.g. cement wall or brick wall. Do NOT attempt to install the TV on a flexible wall such as sand wall or plaster wall, unless the bolt are fixed on an area with standard building rigidity which sustains the weight of the TV and speakers. If the rigidity of the wall can not be measured, every mounting hole should sustain a frontal force of over 100N and a shearing force of over 200N.
7.Use the specified electric drill and drill bit for drilling. The drilling holes should conform to the specifications.
8.To avoid fire and shock, do NOT place radiator, heater or humidifier below the installed TV.
9.The TV should be kept away from moisture, sensors and power line. The TV should be kept away from impact and vibration.
10.Ensure that the power supply be disconnected before installation for fear of fire and shock.
Wall-mounting Installation Steps:
1.Take out the brackets from the package, and check if there are serious defects (e.g. infirm juncture).
2.Adjust the bracket to the desired angle. Use the bolts 2 to adjust the angle by meeting holes of column beam 8 and holes of lever 5
3.Drill locating holes in the specified dimension in a vertical wall of concrete or brick. The hole size should be 11mm. The hole depth should accommodate the expanding tube of the bolt.
4.Fix the bolts into the drilled holes in step3, and then cover each bolt with a metal washer. Meet the four mounting holes in the bracket with the four bolts in the wall, cover each bolt with a metal washer, and then fasten with a screw nut. Check its rigidity by pulling the bracket.
5.Fix the fixture disk 4 to the back cover of the TV using four bolt 3(M8X45).
6.
7.If the customer is not satisfied with the mounting angle, take down the TV and adjust the angle before
8.After