Appendix
| SCART arrangement 2 |
| |
Pin Signal | Signal level | Impedance | |
1 | Audio output B (right) | 0.5V rms | <1kohm |
2 | Audio input B (right) | 0.5V rms | >10kohm |
3 | Audio output A(left) | 0.5V rms | <1kohm |
4 | Ground (audio) | - | - |
5 | Ground | - | - |
6 | Audio input A(left) | 0.5V rms | >10kohm |
7 | - | - | - |
8 | Function select (AV control) | High(5 - 12V) - AV mode | >10kohm |
|
| ||
|
| Low |
|
9 | Ground | - | - |
10 | - | - | - |
11 | - | - | - |
12 | - | - | - |
13 | Ground | - | - |
14 | Ground (blanking) | - | - |
15 | - | 0.3V | 75ohms |
16 | - | - | - |
17 | Ground | - | - |
18 | Ground | - | - |
19 | Video output | 1V including sync | 75ohms |
20 | Video input | 1V including sync | 75ohms |
21 | Common ground (shield) | - | - |
WARNING: Do NOT attempt to work on ANY equipment unless you KNOW what you are doing.
Notes: Y/C can not be displayed in the PIP source.
Cleaning and care
WARNING: Do not try to remove the cabinet back. Refer servicing to qualified service technicians.
To clean the TV screen:
1)Unplug the TV to avoid possible shock hazard.
2)Use a clean cellulose sponge or chamois clothdampened with a solution ofmild detergent and warm water to clean the TV screen and trim. Do not use too much water as water spilled into the cabinet can cause damage to theTV.
3)Wipe off any excess moisture with aclean dry cloth.
4)Polish the cabinet with a quality furniture polish to maintain thefinish and appearance of thecabinet.
Caution: Never use strong solvents such as thinner, benzene, or other chemicals on or near the cabinet. These chemicals can damage the finish ofthe cabinet.