Connecting a Standard TV

16-419.fm Page 7 Tuesday, July 20, 1999 11:16 AM

Follow these steps to connect the VCP to a standard TV that has a 75-ohm cable jack, but does not have separate audio and video input jacks.

1.Disconnect the antenna or cable wire from your TV’s VHF antenna terminal and connect it to the VCP’s ANT.IN terminal.

Notes:

•If your antenna has a 300-ohm wire, connect the wire to the 300-ohm terminals on the supplied 300-to-75-ohm adapter. Then connect the adapter’s 75-ohm plug to the VCP’s ANT. IN terminal.

•If you have a VHF/UHF splitter connected to your TV, disconnect the antenna wire from the splitter’s input terminal and leave the splitter connected to the TV.

•If you have a separate UHF antenna, leave the UHF antenna wire connected to the TV.

2.Using the supplied 75-ohm coaxial cable, connect the VCP’s RF.OUT terminal to the TV’s VHF antenna terminal (or the splitter’s input terminal).