Important Safeguards and Precautions
Before Using
Congratulations
Head Cleaning
• Important
FOR YOUR SAFETY, READ AND RETAIN ALL SAFETY AND OPERATING INSTRUCTIONS. HEED ALL WARNINGS IN THE MANUAL AND ON THE UNIT
INSTALLATION
1POWER SOURCE CAUTION
Operate only from a power source indicated on the unit or in this manual. If necessary, have your Electric Utility Service Company or Video Products Dealer verify the power source in your home.
2POLARIZED OR GROUNDING PLUG
As a safety feature, this Video product comes with either a polarized power cord plug (one blade is wider than the other), or a
OUTDOOR ANTENNA INSTALLATION
1SAFE ANTENNA AND CABLE CONNECTION
If an outside antenna or cable system is connected to the equipment, be sure the antenna or cable system is grounded so as to provide some protection against built up static
charges and voltage surges.
Section 810 of the National | NEC - NATIONAL |
ELECTRICAL CODE | |
|
Electrical Code, ANSI/NFPA 70 (in Canada, part 1 of the
Canadian Electrical Code) provides information with respect to proper grounding of the mast and supporting structure, grounding of the
of grounding conductors, location of antenna discharge unit, connection to grounding electrodes and requirements for the grounding electrode.
on your new purchase! With proper use, this dependable product will provide years of enjoyment. Please fill in the information below. (Serial number is on tag on back of VCR.)
•Date of Purchase
•Dealer Purchased From
•Dealer Address
•Dealer Phone No.
•Model No.
•Serial No.
Old or damaged tapes may clog heads.
Video Head Clog Sensor
play if clogging is detected. | V I DEO HEADS MAY |
To remove screen, press | NEED CLEAN I NG |
PLEASE I NSERT HEAD | |
PLAY. | CLEAN I NG CASSETTE |
OR REFER TO MANUAL | |
• Use “dry” type head | END : PLAY |
cleaning cassette only. |
|
(Part No.
•Follow cleaning tape instructions carefully. Excessive use of tape can shorten head life.
Safeguards •
POLARIZED PLUG CAUTION:
This plug will only fit into an outlet one way. If you cannot fully insert the plug, try reversing it. If it still will not fit, have an electrician install the proper wall outlet. Do not defeat the safety feature by tampering with the plug.
GROUNDING PLUG CAUTION:
This plug will only fit into a
3 POWER CORD |
Make sure power cords are routed so that they |
are not likely to have anything rest on them, roll |
over them, or be in the way of walking traffic. |
If an extension cord is used, make sure it also |
has either a polarized or grounded plug and that |
the cords can be securely connected. Frayed |
cords, damaged plugs, and damaged or cracked |
wire insulation are hazardous and should be |
replaced by a qualified service technician. |
Overloaded outlets and extension cords are fire |
2KEEP ANTENNA CLEAR OF HIGH VOLTAGE POWER LINES OR CIRCUITS
An outside antenna system should be located well away from power lines, electric light or power circuits and where it will never come into contact with these power sources if it should happen to fall. When installing an outside antenna, extreme care should be taken to avoid touching power lines, circuits or other power sources as this could be fatal. Because of the hazards involved, antenna installation should be left to a professional.
USING THE VIDEO UNIT
If the unit has been in storage or moved to a new location, refer first to the INSTALLATION section of these safeguards.
1 | KEEP THIS VIDEO UNIT AWAY FROM WATER OR |
| MOISTURE OF ANY KIND. |
2 | IF EQUIPMENT IS EXPOSED TO RAIN, MOISTURE, OR |
| STRONG IMPACT, unplug the unit and have it inspected by |
| a qualified service technician before use. |
3 | DURING AN ELECTRICAL STORM |
| During a lightning storm, whether indoors or outdoors, or |
| before leaving the unit unused for extended periods of time, |
Accessories
Remote Control
LSSQ0263 (PV-V4022) LSSQ0264 (PV-V4522)
POWERDISPLAY
VCR TV
VCR/TV
1 2 3
INPUT
4 5 6
SPEED
7 8 9
EJECTADD/DLT
100 0
CM/ZERO SEARCH
|
| PLAY |
|
REW | SELECT | FF | |
|
|
| |
ACTION |
| STOP | PROG |
REC | TAPE | RESET | |
POSITION COUNTER PAUSE/SLOW | |||
| VOL | CH | |
|
|
| TRACKING |
Batteries 2 “AA”
RF Coaxial
Cable
VJAS0196
Cleaning the VCR
Use soft, dry cloth or dusting attachment of a vacuum to remove dust from all cabinet vent holes. You may moisten cloth with nonabrasive, antistatic cleaner/ polisher.
Caution:
Alcohol and various solvents could damage finish.
Specifications
Power Source: | 120 V AC, 60 Hz |
Power Consumption: Power On | |
| Approx. 18 W |
| Approx. 23 W |
Accessories • Head Cleaning •
hazards and should be avoided. |
4 DO NOT BLOCK VENTILATION HOLES |
Ventilation openings in the cabinet release heat |
generated during operation. If they are blocked, |
heat |
that may result in a fire hazard or heat damage |
to cassettes. For protection, follow these rules: |
a. Never cover ventilation slots or the unit while |
in use, or operate the unit when placed on a |
bed, sofa, rug, or other soft surface. |
b. Avoid |
case or rack, unless proper ventilation is |
provided. |
5 AVOID EXTREMELY HOT LOCATIONS OR |
SUDDEN TEMPERATURE CHANGES |
Do not place the unit over or near any kind of |
heater or radiator, in direct sunlight, inside a |
closed vehicle, etc.. Do not move the unit |
suddenly between areas of extreme temperature |
variation. If the unit is suddenly moved from a |
cold place to a warm place, moisture may |
condense in the unit and on the tape. |
6 TO AVOID PERSONAL INJURY |
• Do not place unsecured |
equipment on a sloping |
surface.
• Do not place this unit on any support that is not firm, level, and adequately strong. The unit could fall causing serious injury to a child or adult and damage to the unit.
• | An appliance and cart combination should be |
| moved with care. Quick stops, excessive force, |
| and uneven surfaces may cause the appliance |
| and cart combination to overturn. |
• | Carefully follow all operating instructions and |
| use the manufacturer's recommended |
| disconnect all equipment from the power source as well as | |
| the antenna and cable system. | |
4 WHEN THE UNIT IS PLUGGED IN | ||
| • | Never expose the unit to rain or water. DO NOT |
|
| OPERATE if liquid has been spilled into the unit. |
|
| Immediately unplug the unit, and have it inspected by a |
|
| service technician. Fire and shock hazards can result from |
|
| electrical shorts caused by liquid contact inside. |
| • | Never drop or push any object through openings in the |
|
| unit. Some internal parts carry hazardous voltages and |
|
| contact can cause electric shock or fire hazard. |
| • | Avoid placing the unit directly above or below your TV set |
|
| as this may cause electrical interference. Keep all |
|
| magnets away from electronic equipment. |
5 | USING ACCESSORIES | |
| Use only accessories recommended by the manufacturer to | |
| avoid risk of fire, shock, or other hazards. | |
6 | CLEANING THE UNIT | |
| Unplug the unit. Then, use a clean, dry, chemically | |
| untreated cloth to gently remove dust or debris. DO NOT | |
| USE cleaning fluids, aerosols, or forced air that could over- | |
| spray, or seep into the unit and cause electrical shock. Any | |
| substance such as wax, adhesive tape, etc. may mar the | |
| cabinet surface. Exposure to greasy, humid, or dusty areas | |
| may adversely affect internal parts. |
SERVICE
1 DO NOT SERVICE THIS PRODUCT YOURSELF |
If, after carefully following the detailed operating instructions, |
this Video product does not operate properly, do not attempt |
to open or remove covers, or make any adjustments not |
described in the manual. Unplug the unit and contact a |
qualified service technician. |
2 IF REPLACEMENT PARTS ARE REQUIRED |
Make sure the service technician uses only parts specified |
by the manufacturer, or those having the same safety |
characteristics as the original parts. The use of unauthorized |
substitutes may result in fire, electric shock, or other |
Model
To order accessories, call toll free
Loading the Batteries
Battery replacement caution
•Do not mix old and new batteries.
•Do not mix alkaline with manganese batteries.
Prevent Accidental Tape Erasure
| Power Off |
| Approx. 2.5 W |
| Approx. 3.0 W |
Video Signal: | EIA Standard NTSC color |
Video Recording | 4 rotary heads helical |
System: | scanning system |
Audio Track: | 1 track (Normal) |
| 2 channel |
|
Tuner:
Broadcast Channels: VHF 2 ~ 13, UHF 14 ~ 69
CABLE Channels: Midband A ~ I (14 ~ 22) Superband J ~ W (23 ~ 36) Hyperband AA ~ EEE
(37 ~ 64)
Lowband
Ultraband 65 ~ 94, 100 ~ 125
Operating
Temperature: 5 ° C ~ 40 ° C (41 ° F ~ 104 ° F)
Operating Humidity: 10 % ~ 75 %
Weight:2.5 kg (6.0 lbs).
Dimensions: 360 (W) x 93 (H) x 242 (D) mm
Note: Designs and specifications are subject to change without notice.
Loading Batteries • Prevent Tape Erasure • Specifications
accessories when operating this unit or |
connecting it to any other equipment. |
Safety Precautions
hazards. |
3 HAVE THE SERVICE TECHNICIAN PERFORM A SAFETY |
CHECK |
After any service or repairs to the unit, request the service |
technician to conduct a thorough safety check as described |
in the manufacture’s service literature to ensure that the |
video unit is in safe operating condition. |
Break off the tab to prevent recording.
To record again
Features for a Quality Picture
Digital Auto Picture
Automatically controls the video output signal for less noise depending on the tape condition.
•
Warning: To prevent fire or shock hazard, do not expose this equipment to rain or moisture.
CAUTION: To prevent electric shock, match wide blade of plug to wide slot, fully insert.
Avertissement: Afin de prévenir tout risque d’incendie ou de chocs électriques, ne pas exposer cet appareil à la pluie ou à une humidité excessive.
Record Tab
Screw driver
Cover the hole with cellophane tape.
Digital Auto Tracking
Continuously analyzes the signal and adjusts for optimum picture quality.
Manual Tracking Control
(to reduce picture noise)
Record/Playback
Attention: Pour éviter les chocs électriques, introduire la lame la plus large de la fiche dans la borne correspondante de la prise et pousser jusqu’au fond.
Record/Playback Time
Use during Playback and Slow Motion mode to reduce picture noise.
CAUTION |
RISK OF ELECTRIC SHOCK |
DO NOT OPEN |
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, |
DO NOT REMOVE COVER (OR BACK) |
NO |
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL |
This symbol warns the user that uninsulated voltage within the unit may have sufficient magnitude to cause electric shock. Therefore, it is dangerous to make any kind of contact with any inside part of this unit.
This symbol alerts the user that important literature concerning the operation and maintenance of this unit has been included. Therefore, it should be read carefully in order to avoid any problems.
Only use tapes with the |
|
| mark in this unit. | ||
|
| ||||
Tape Speed | Type of Video Cassette | ||||
|
|
|
|
| |
Setting | T60 | T120 | T160 | ||
SP | 1 Hour | 2 Hours | 2 Hours | ||
(Standard Play) | 40 Minutes | ||||
|
|
|
|
|
|
LP | 2 Hours | 4 Hours | 5 Hours | ||
(Long Play) | 20 Minutes |
Press CH (TRACKING) / on the remote control or on the VCR until the picture clears up. To return to Auto Tracking, press POWER off, then on again a few seconds later.
R |
| R |
| |
R | R | R | R | |
R | R | |||
|
|
Time
FCC Warning: Any unauthorized changes or modifications to this equipment would void the user’s authority to operate.
SLP | 3 Hours 6 Hours 8 Hours |
(Super Long Play) |
In Still mode, CH (TRACKING) / operate as a
- 2 - | - 3 - |