Panasonic NV-FJ735AM, NV-FJ730 Connections, Setting the Remote Control to Operate Your TV

Setting the Remote Control to Operate Your TV

You can operate the TVs of the manufacturers listed below with the remote control after setting it.

This setting procedure allows you to operate the TVs of some manufacturers using the supplied remote control.

Preparation

–Set the VCR/TV switch E to [TV].

Operations

1 Find the manufacturer number of your TV while

referring to the following table.

Connections

This section shows you how to connect the VCR to an aerial, TV, etc.

When the VCR is turned on after unpacking and connecting the aerial cable and the mains lead, Plug in Auto Tuning starts automatically.

Basic Connections

The following connections are required to record and play back the video cassette through the TV.

Aerial (Not supplied)

TV Set (Not supplied)

2 While holding down the POWER button 1 , use the

Numeric buttons 2 to enter the manufacturer number.

This completes the settings for the TV manufacturer.

– Be sure to enter the number in two digits.

Example: 1 ) 01

3 To confirm the correct settings were made, check

whether the TV can be operated properly.

– When a manufacturer has multiple numbers in the

following table, try entering other numbers if the TV

operations cannot be performed properly, and then

select the optimal number.

Notes:

– If you are using a Panasonic TV, this setting has already

been made, and so you do not need to perform the above

setting procedure. However, this remote control may not

	2
Cable Strap	Aerial Connector
	VIDEO
	L
	AUDIO
	R
	IN (AV1)OUT
3
To mains supply

∫To loose a Cable Strap

Push up a strap in the direction of the arrow, pushing a Lock Tab.

1

Aerial Input socket h

I N

OUT

RF

Aerial Output socket i

Cable Strap

work with some Panasonic TVs.

– Some TV models cannot be operated using this remote

control (including all TVs non-remote compatible).

List of TVs Compatible with the VCR’s Remote Control

[Brand]	[Code]
Panasonic/National	01–04
SONY	05
TOSHIBA	06
JVC	07
HITACHI	08
MITSUBISHI	09, 10
SHARP	11
PHILIPS, SAMSUNG	12
NEC	13
SANYO	14
GOLDSTAR/LG	15, 16
SAMSUNG	17, 18
SANYO	19

Lock Tab

Connection to a TV using the Audio/Video Input Socket: Set the RF output channel of the VCR to [ss] (RF OFF) when the VCR is connected to the TV via the Audio/Video cable. (See page 6.)

Aerial (Not supplied)

	TV Set (Not supplied)
Aerial Connector			1
	2	VIDEO IN
Cable Strap		AUDIO IN	Aerial Input
	3	(Supplied)
			socket h
	VIDEO		I N

L

AUDIO

R	OUT
IN (AV1)OUT	RF
4	Aerial Output
To mains supply	socket i
	VIDEO OUT c /
	AUDIO OUT e

Connection to a Stereo Amplifier
	PLAYBACK
	(Not supplied)		I N
	REC		OUT
Stereo amplifler (Not supplied)
	IN (AV1)	OUT	RF
	AUDIO IN d		AUDIO OUT f/g

5