Panasonic PV DM2093, PV DM2793 ADD/DLT Select SET Stop Prog, To Replace program, To Clear program

*Important: If a remote control button does not work when pressed, press the TV/VCR button on the remote and try the button again.

Cancel a Timer Recording: (Recording is in progress)

Hold down STOP for a few seconds to cancel the Timer Recording.

•Any future daily or weekly recordings will be performed as programmed.

ADD/DLT

SELECT

SET

STOP

PROG

Review, Replace or Clear Program Contents : (Recording is not in progress)

1 Repeat steps 1 and 2 on page 30.

2								Press	to select
								the desired program.
	CANCEL : ADD / DLT
	SELECT 1 - 8 :
	ENTER			: SET
	END			: PROG
3 To Replace program...
	DATE			START	STOP		CH	1) Press SET to
	8 SAT			9:00P 12:00A			08
	TO		DAY					display.
------------------------								2) Press	to select
						SLP
								and press SET
	SELE CT START DATE
	SELECT :							or	to set new
	SET			: SET	BACK :
	END			: PROG				program contents.
								3) Press PROG.
	To Clear program...
	P DT START				STOP	CH SPD		Press ADD/DLT.
	1		-- -- : -- -- : --			--	--
	2		8 10 : 00p12 : 00a 125				SP
3		10		8 : 00p 9 : 00p 10			SP
4			SU	9 : 00p10 : 00p L LP
		SELECT 1 - 8 :
		ENTER : SET
		END		: PROG

4 Press PROG twice to exit this mode.

Notes

•2 minutes before Timer recording is performed, “PLEASE PREPARE FOR TIMER REC” appears and/or the PROG TIMER Indicator flashes. Be sure a cassette with record tab is loaded and the unit is in Stop mode.

•If the start times of two programs overlap, the lower numbered program will have priority.

•If the start time for a Timer Recording comes up during a normal recording or One Touch Recording (page 18), the Timer Recording will not be performed.

•If there is a power interruption of more than one minute, the recording may not be performed or continued.

•If “INCOMPLETE” appears after all items have been set, check all entries and make necessary corrections.

Timer Operation

31