Installation
EQUIPMENT PLACEMENT
The unit can be placed on any flat surface (desk or table). Rack mounting hardware is provided for mounting the unit in an equipment rack.
Position the unit to allow for cable and power cord clearance at the rear of the unit. Be sure that the air flow around the unit is not obstructed.
WARNING: Do not place the unit on its side. In this position, the unit is likely to fall over and may cause equipment damage or personal injury.
EQUIPMENT CONNECTIONS OVERVIEW
Figure 5 shows the equipment connections for the unit.
NOTE: Refer to the KBD300USBKIT Installation manual for information about installing the KBD300A keyboard.
Figure 5. Equipment Connections Overview
IMPORTANT NOTE. PLEASE READ. The network implementations in this document are shown as general representations only and are not intended to show detailed network topologies. Your actual network will differ, requiring changes or perhaps additional network equipment to accommodate the systems as illustrated. Please contact your local Pelco Representative to discuss your specific requirements.
C4675M (2/11) | 15 |