Getting Started (controls)
CLEAR Used in
DISPLAY Used in
VOLUME Increase or decrease the audio volume.
MUTE Turns off the audio until you press MUTE again.
REC Starts recording on the station the VCR is set to.
REW Rewinds the videotape.
PLAY Starts playing a loaded cassette.
PAUSE Temporarily stops the cassette from recording or playing. Press PAUSE again (or PLAY) to resume.
0 to 9 Number buttons used in
AVX Used for recording from an auxiliary input such as a stereo system.
VCR1, VCR2, TV Device buttons let you set the remote to control one of the three devices.
CHANNEL Top button switches to the next higher channel, bottom button switches to the next lower channel. For these to operate, you must have preset your channels.
LAST CHANNEL Switches to the TV channel you watched 3reviously during the current viewing session.
F.FWD Fast forwards the videotape.
STOP Stops a videocassette from playing, recording, pausing, rewinding - or anything it is doing.
LIGHT Illuminates key function buttons for a few seconds.
SHUTTLE Controls the videocassette's forward and reverse motion with one convenient dial.
When the Remote Doesn't Work Right
Check out these possibilities:
Low Battery
If the remote is not working even at close range, try putting in two fresh AA batteries.
When replacing the batteries, remove the old batteries and press the POWER button on the remote and hold it for about 10 seconds, then insert two fresh batteries.
Objects in the Way
There may be objects between the remote and the VCR - for instance, a stack of books on the coffee table, your
Set to Wrong Device
It may be set to VCR2 when you're trying to control VCR1. To confirm that this is the case, try pressing VCR2 and a function button (like channel up or down). If the remote works now, you know that it'sset to VCR2. To reset it to VCR1, refer to the