Hitachi VT-F382A owner manual For Yoursafety

Page 4

FOR YOURSAFETY

POWER SUPPLY: AC 120V, 60 Hz ONLY.

The POWER switch turns the VCR on and off, leaving the clock/timer unaffected. If the unit is to be left unattended for a long period, it is recommended that the unit be completely switched off and unplugged. Illustrated below is the label on the back of your unit.

the user that uninsulated voltage within the unit may have sufficient magnitude to cause electric shock. Therefore. it is dangerous to make any kind of contact with any inside part of this unit.

_This symbol alerts the user that important literature concerning the

operation and maintenance of this unit has been included. Therefore. it should be read carefully in order to avoid any problems

CAUTION: TO REDUCE THE RISK OF ELECTRIC

SHOCK. DO NOT REMOVE COVER (OR BACK).

NO USER-SERVICEABLE PARTS INSIDE.

REFER SERVICING TO QUALIFIED SERVICE PERSONNEL

WARNING: Many television programs and films are copyrighted. In certain circumstances, copyright law may apply to private in-home videotaping of copyrighted materials.

WARNING: TO PREVENT FIRE OR ELECTRIC SHOCK. DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.

CAUTION: TO PREVENT ELECTRIC SHOCK. MATCH WIDE BLADE OF PLUG TO WIDE SLOT FULLY INSERT.

Caution to user: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

"Note to CATV system installer: This reminder is provided to call the CATV system installer's attention to Article 820-40 of the NEC that provides guidelines for proper grounding and. in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical".

Image 4

Contents VT-F382A Using these quality featuresH9RIB1 Canada Display Indicators Meet Your On-Screen Guide VCRProgramming Remote Control Controlling For Yoursafety Quick Index It Ei LMPORTANTSAFEGUARDS USE LMPORTANTSAFEGUARDS Hook up the AudioNideo Signal Decide Where to Put Your VCRDecide Which Hookup Method to Use TV with Audio and Video Jacks Hook up the RF SignalSimple Antenna/Cable 75 Ohm Hookup External or Internal 300 Ohm Antenna If you have Use this adapterAttach the TV and VCR to the Power Supply Install Batteries in the Remote Control Set the RF or Video Channel SwitchHow the Remote Control Works About the Illuminated ButtonsGetting Started controls If You Just Want to Watch TV Display IndicatorsMeet Your On-ScreenGuide Getting Started Controls Initial Setup Options Setting the Clock Choosing a Mode for Audio Playback More About Channel SelectionsRemoving Channels Stereo vs. Mono SoundHi-Fi Sound Safety Tabs Prevent Erasure TypesTape Capacities at Different Speeds Types Recording TimeTape Storage Direct Video Input to the TV To play Back a Recorded TapeTo Fine Tune the Picture Rewinding the Tape Manual RewindMovie Return Special Playback EffectsTo Find Specific Sections on a Tape Visual Search Using the Shuttle Control on the remote controlSearching with the Time Counter Jump Forward or Backward with GO-TO Marking with the Time CounterJump to an Index Mark with Index Basic Operations Before you Record Copyright Infringement WarningBasic Recording Steps Recording Tips To Watch the Same Program While RecordingUsing the Instant Recording Timer IRT To Change the Channel Being RecordedTo Leave Index Marks on the Tape To Record a Second Audio Program SAPSetting the VCR to Record Later Types of Delayed RecordingsDelayed Recording Steps DailyTo Stop a Delayed Recording in Progress An ExampleReviewing What You Have Programmed Programming PrioritiesShows with Same Starting Time Shows with Different Starting TimesChannel Setup Before You Begin About VCR Plus+Basic Operations VCR Plus + Recording Dilve Basic operations VCR Plus + Recording Basic Operations VCR Plus + Recording Weekly Recording Compatibility Programming the Remote ControlTV Brands Press IV and This Number NEC RCA JVCLast DisplayBasic hookup Position Cable BoxAdvanced hookup Cable Box to unscramble all channels AdVanced OperationsCable Box HookUps Hookup Recording from Your Stereo SystemTo Control Both VCRs with the Remote Control Copying from One VCR to Another DubbingHookup When VCR1 is Recording Synchro EditingCopying Tapes From a Camcorder Putting The Record VCR in PauseInformation on Audio Hookup Periodic Maintenance Head CleaningDont Attempt Repairs Yourself Design and specifications subject to change without notice VHSOften Encountered Problems Problem Things To Check SolutionHitachi Service Hotline You must state your zip code when calling CanadaContinental U.S.A Days a week, 24 hours a day