JVC HR-J248EE Engage RECORDER’S, Timer Mode, Engage Auto SP/LP, Auto SP/LP Timer HR-J448EE only

1	2	3	DAILY
4	5	6

7 8 9 WEEKLY

EN23

RETURN TO NORMAL

SCREEN

8 After confirming all information is correct, press OK and the normal screen appears.

●Repeat steps 1–8for each additional programme.

ENGAGE RECORDER’S

0

2

TIMER

TIMER MODE

9 Press TIMER. The recorder turns off automatically.

1 3 Á

¦ 7 8

1	4	¢
	3

OK

	SP/LP	TIMER
AUTO
		2	3

q 5/8 6

AUTO SP/LP TIMER Indicator

NOTES:

●The Auto SP/LP Timer feature is not available during ITR (Instant Timer Recording), and the feature will not work properly with any tapes longer than E-180 as well as some tapes of shorter lenghs.

●Even if, in step 1, you press AUTO SP/LP TIMER and it lights up, that doesn’t mean that the recorder will automatically change from SP to LP (or EP) mode during the course of the recording. Watch the tape later to confirm.

●If you have programmed the recorder to timer-record 2 or more programs, the second programme and those thereafter may not fit on the tape if you engage the Auto SP/LP Timer mode. In this case, make sure the mode is not engaged, then set the tape speed manually during timer programming.

●There may be some noise at the point on the tape where the recorder switches from SP to LP (or EP) mode.

To Timer-Record Weekly Or Daily Serials . . .

. . . anytime during steps 2 through 8, press WEEKLY (NUMBER key “9”) for weekly serials or DAILY (NUMBER key “8”) for daily serials (Monday–Friday). Either "WEEKLY" or "DAILY" appears on the screen. Pressing the button again makes the corresponding indication disappear.

NOTES:

●You can programme this recorder to timer-record as many as

8 programmes. If you try to programme the recorder to record a ninth, "PROGRAM FULL" appears on screen. To record the extra programme, you must first cancel any unnecessary programmes (☞ pg. 24).

●In case of a power failure after programming, the recorder’s memory backup keeps your selections (if the lithium battery is not exhausted).

Auto SP/LP Timer (HR-J448EE only)

If, when recording in SP mode, there is not enough tape to record the entire programme, the recorder automatically switches to LP mode (with PAL broadcasts) or EP mode (with NTSC broadcasts) to allow complete recording.

	ENGAGE AUTO SP/LP
1	TIMER
	Press AUTO SP/LP TIMER on the recorder front panel.
	The AUTO SP/LP TIMER indicator lights up.
	For Example . . .
	Recording a PAL-broadcast program of 210 minutes in
	length onto a 180-minute tape
		Approximately 150	Approximately 60
		minutes	minutes
		SP mode	LP mode

Total 210 minutes

After the recorder's Timer mode is engaged, make sure the AUTO TIMER SP/LP indicator is still lit; if not, press AUTO TIMER SP/LP so that the indicator lights.