JVC HR-J695EK, HR-J696EK Check the Results, Finish Off, Go straight to 2000 used as example only

12

three-step quick start

Check the Results

When Auto Setup or Preset Download finishes, you will see one of the three following examples on the VCR display panel:

The Preset Positions and the Clock have been set successfully

Go straight to Step 3 (20:00 used as example only).

The Preset Positions have been set successfully but the Clock has not

Perform Clock Set on page 52.

Go to Step 3.

Neither the Preset Positions or the Clock have been set successfully

Make sure the cables are connected properly to the VCR and turn the VCR off and then on again. Try Auto Set Up or Preset Download again.

						ENTE
							R/EN
							TR
		MENU				3	OK /	EE
					TV	PR
							+
T								+
V
	–							V
								T
					TV	PR –
	TV
		TV/VCR	AUDIO		– –:– –
	1	2			3
					2
	4	5			6
	VPS/PDC	DAILY/QTDN. WEEKLY/HEBDO
	7	8			9
	0000	AUX			4
		0
	START	STOP	DATE		PR
	DEBUT	FIN
		EXPRESS
1	PROG	?			30 SEC
			ENTER/ENTREE
	MENU		PR	3	OK
		TV		+
	T				+
	V
	–				TV
		TV PR		–

Finish Off

Select the Video channel or AV mode, then make sure that all necessary stations have been stored in the VCR’s memory by using the Aand Bbuttons.

If station names (ID — ☞ pg. 50) have also been stored in the VCR’s memory, the station name will be displayed at the top left corner of the TV screen for about 5 seconds each time you select a different channel via the VCR.

The VCR is now set up. You can now use it to play and record.

IMPORTANT

•re-running setup Auto Setup or Preset Download may not behave as described if it has already been run on the VCR. This is because some of the information gathered on the first Auto Setup or Preset Download is retained in memory and that part of the process may be skipped by the VCR.

•bad reception In certain reception conditions, station names may not be stored correctly, and Guide Program Numbers may not be set properly. If this happens, when you timer-record a TV programme using the VIDEO Plus+ system, the VCR will record a TV programme of a different station. When programming the timer using the VIDEO Plus+ system, be sure to check that the preset position corresponding to the broadcasting station you wish to record has been selected (☞ pg. 21, VIDEO Plus+ Timer Programming).

•duplicate stations You may be able to receive the same station from two different transmitters in which case Auto Setup will detect and store both. It is normal for one transmitter to give you a better quality picture than the other; to delete those stations which have a poor picture ☞ Delete A Channel on page 48.

•manual station setting If any of the above problems occur, refer to pages 48 – 49 to input station names (☞ Change Station Name). You can also change station preset positions (☞ Change Station Preset Position).

•rf connections In certain reception conditions, the Video Channel may not be set correctly and interference may appear in the TV picture while the VCR’s power is on. Set your Video Channel manually. (☞ pg. 45, Video Channel Set)

IF YOU HAVE ANY DIFFICULTY WITH THE ABOVE PROCEDURES CALL THE JVC CUSTOMER SERVICE HOT LINE ON 0870 330 5000